Agri-Fab 45-02101-101 Manual do Proprietário - Página 9

Procurar online ou descarregar pdf Manual do Proprietário para Espalhador Agri-Fab 45-02101-101. Agri-Fab 45-02101-101 12 páginas. Pro 125# broadcast spreader
Também para Agri-Fab 45-02101-101: Manual do Proprietário (12 páginas), Manual do Proprietário (12 páginas)

Imprimir página

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983

IMPORTANT:

Application rates (shown on chart) are

affected by humidity and mixture content of material (granu-

lar and pellet). Minor adjustment of the flow rate setting may

be necessary to compensate for these variables. The rate

chart is calculated for light and heavy application. The faster

you walk, the wider the broadcast width. A variation in speed

will determine the flow rates and width of broadcast.

NOTE:

We do not recommend the use of powdered

materials due to difficulty in obtaining a satisfactory or

consistent broadcast pattern.

APPLICATION CHART (SHIELD UP)

TYPE

FLOW SETTING

MATERIAL

(100 FT. IN 23 SEC.)

FERTILIZER

Powder

Granular

Pelleted

Organic

GRASS SEED

Fine

Coarse

ICE MELTER

APPLICATION CHART (SHIELD DOWN)

TYPE

FLOW SETTING

MATERIAL

(100 FT. IN 17 SEC.)

FERTILIZER

Powder

Granular

Pelleted

Organic

GRASS SEED

Fine

Coarse

ICE MELTER

SPREAD

3 MPH

WIDTH

IN FEET

3 - 5

3 - 4

3 - 5

8 - 10

3 - 5

10 - 12

6 - 8

3 - 4

6 - 7

4 - 5

8 - 9

6 - 8

10 - 12

SPREAD

3 MPH

WIDTH

IN FEET

1 - 3

3 - 4

1 - 3

3 - 4

1 - 3

3 - 4

1 - 3

3 - 4

2 - 3

3 - 4

2 - 4

3 - 4

www.mymowerparts.com

LUBRICATION

1. Apply a little automotive grease to the sprocket and gear.

2. Oil nylon bushings on sprocket shaft. See figure 17.

3. Oil axle/shaft bushing on axle as shown in figure 17.

4. Oil right hand wheel bearing as needed.

OIL

GREASE

FIGURE 17

MAINTENANCE & STORAGE

1. Do not store spreader with any material in hopper.

2. Clean your spreader after use. Flush thoroughly with

water.

3. If for any reason the axle, gear and sprocket assembly

is disassembled, be sure to mark position of parts as

they are removed. Drive wheel and sprocket position

determine relation direction of spreader plate. With

reassembly of gear and sprocket use shim washers as

needed for minimum backlash. Add grease to gear and

sprocket.

4. If agitator wire becomes damaged or worn it can be

replaced. Loosen 3/8" hex nut at top end of sprocket

shaft until agitator wire is free. Remove old agitator wire

from hole in agitator sleeve and replace with new agita-

tor wire. Position agitator wire so that sprocket shaft

turns freely and tighten 3/8" hex nut on top of sprocket

shaft. See figure 18.

SPROCKET

SHAFT

AGITATOR

WIRE

AGITATOR

SLEEVE

FIGURE 18

SPROCKET

SHAFT

OIL

3/8" HEX NUT