Dato L-B200 Manual do utilizador - Página 8

Procurar online ou descarregar pdf Manual do utilizador para Por fechaduras Dato L-B200. Dato L-B200 12 páginas.

6,Testing the fundamental functions: when the external handle is pressed, the door shall be tightly locked

without the fingerprint input for identification; when any fingerprint is input for identification with further

press to the external handle, the door shall be open successfully( only the recorded fingerprint is allowed

to unlock the door after the fingerprint setting)

7, Finish the installation:insert the rear handle from the other side of the door by aligning the quad slot

with the spindle(remember to put the rubber pad in advance), and tighten and secure with two mounting

screws from two holes in the rear handle into the screw holes of the connecting screws.

Note: A. The two

screws should be screwed as tightly as possible. B. The screw close to the door handle is not easy to

install and additional attention is required.

8,Test after the installation:

a, When the front handle is pressed, the door shall be tightly locked without the fingerprint input for

identification; when any fingerprint is input for identification with further press to the front handle, the door

shall be open successfully( only the recorded fingerprint is allowed to unlock the door after the fingerprint

setting).

NOTE: If you find any fingerprint could be identified after fingerprint setting, which means the fingerprint

record failed, please refer to the instruction book to do fingerprint record again

b,Press the internal handle and the door shall available to open

Lock settings

Press the setting switch by rotating the mechanical key clockwise about 15-20 degrees, long press or

about 3 seconds until the blue indicator on and release the switch after 1 beep. Press the finger to set at

the center of the fingerprint area, if the data is collected successfully, the blue indicator will flash once and

a beep will be sounded to remind that a fingerprint is acquired; if there is a in-proper input or failure, the

red indicator will flash once and "tick" two times to remind the invalid collection. A total of 5 times are

needed for any single fingerprint collection. The blue indicator is always on and a long beep will be

sounded to indicated the successful fingerprint acquisition. The blue indicator will flash throughout the

fingerprint entry process(to indicated the entry status), but not in multiple colors.

Note:

a, The finger to touch press requires multiple angles to collect, which benefits the expansion of the

database as well as the sensitivity of identifications!

b, If you find any fingerprint could be identified after fingerprint setting, which means the fingerprint record

failed, please refer to the instruction book to do fingerprint record again.

Press the setting switch by rotating the mechanical key clockwise about 15-20 degrees, and hold to allow

the the blue indicators to flash for about 5 seconds until the red light indicator on. Release the blue light

immediately after the first beep and all fingerprints will be removed after a long beep.

3, Fingerprint Identification to Unlock

Press the fingerprint, if the fingerprint is verified, the blue indicator will light shortly with 1 beep, and the

motor will be

triggered to open the lock with automatic gyration after 6 seconds; if the fingerprint is not

verified, the red indicator will light shortly for two times with 2 beeps