4RF Aprisa SRi Manual de início rápido - Página 9

Procurar online ou descarregar pdf Manual de início rápido para Router de rede 4RF Aprisa SRi. 4RF Aprisa SRi 12 páginas.

Page 9

Monitoring and Troubleshooting the Aprisa SRi Radio

When the network is installed, the radio signal strength can be monitored on remote

stations by setting the radio to Test Mode.

To enter Test Mode, press and hold the TEST button on the radio LED panel until all

the LEDs flash green (about 3 - 5 seconds).

In Test Mode, the LED Display panel presents a real time visual display of the RSSI.

This can be used to adjust the antenna for optimum signal strength.

Note: The response time is variable and can be up to 5 seconds.

To exit Test Mode, press and hold the TEST button until all the LEDs flash red (about

3 – 5 seconds).

The OK, MODE and AUX LEDs will be solid green and the TX and RX LEDs will be solid

or flash green if the network is operating correctly.

The RSSI result is displayed on the LED display panel as a combination of LED states.

For more information, please refer to the Aprisa SRi User Manual available from the 4RF website

https://www.4rf.com/secure

(login required).

The Aprisa SRi support extensive alarms for every section and building block of the device including the interfaces. SuperVisor

allows user to view the main summary alarm at the top of the SuperVisor page which mimic the device LEDs and in addition all

the detailed alarms of the device (see SuperVisor > Events > Alarm Summary). In addition, SuperVisor allows user to troubleshoot

any alarm issue by using the event history log page for more information about the alarm (see SuperVisor > Events > Event

History). For more information see the Aprisa SRi user manual.