dymax ACCU-CAL 50-LD Manual do utilizador - Página 16

Procurar online ou descarregar pdf Manual do utilizador para Instrumentos de medição dymax ACCU-CAL 50-LD. dymax ACCU-CAL 50-LD 20 páginas. Led radiometer

Imprimir página

Dymax ACCU-CAL™ 50-LED Radiometer User Guide

6. Press and release the Light Source button to select the light source being measured. For the BlueWave®

QX4™, use the "spot" setting. Repeatedly press the Light Source button until the correct focus lens size

appears on the top line. The options are:

3-mm Spot - For use when measuring a BlueWave® QX4™ Wand with the 3-mm Focus Lens installed



5-mm Spot - For use when measuring a BlueWave® QX4™ Wand with the 5-mm Focus Lens installed



8-mm Spot - For use when measuring a BlueWave® QX4™ Wand with the 8-mm Focus Lens installed



Figure 18. Spot Mode Screens (Shown in Peak Intensity Mode)

7. Press and release the Mode button to select the operating mode. The different operating modes are:

Peak Intensity - Shows the highest intensity in mW/cm



measurement and stores that value in the display.

Intensity - Shows the intensity in mW/cm



readout of intensity.

Dose - Shows the total energy dose in mJ/cm



Note: This measurement is time dependent.

8. Turn on the BlueWave® QX4™ to begin testing.

seen by the detector during the

at the detector during the measurement. This is a dynamic

at the detector during the measurement.