DYNACO Dynalogix II Manual elétrico - Página 4
Procurar online ou descarregar pdf Manual elétrico para Painel de controlo DYNACO Dynalogix II. DYNACO Dynalogix II 12 páginas.
Imprimir página
Setting Limits
Confirm all electrical connections are properly wired and terminated before power up.
STOP
Reference: Wiring Diagram that came with DYNACO Door.
2.0
Setting Limits on Initial Power-up
Automatic activation's should be disconnected prior to setting limits. If connected
!
door may activate and injury or damage may occur.
CAUTION
DYNACO USA, INC,
1. On initial power up the DY4000 will blink SET LIMITS on the display.
2. Press and hold both PROGRAM buttons until display changes to Password.
After display changes, release buttons. See figure: 2.0-1.
RUN
TIMERS
OPEN
JOG
UP/RESET
JOG
MC/PB
DOWN
CLOSE
TIMERS
MENU
Figure 2.0-1: Entering Program Mode
3. Press and release the red arrow buttons to scroll to 562.
Note: On initial start up the Password screen will be bypassed, and will
directly enter the LimitSet screen.
Note: Password number will be stored for 4 minutes after initially entering.
Entering program mode during this time will not require reentry of
password number.
4. Press and release the Enter button. Display should change to: LimitSet.
See figure 2.0-2.
TIMERS
OPEN
JOG
UP/RESET
JOG
MC/PB
DOWN
CLOSE
TIMERS
MENU
Figure 2.0-2: Enter Button
CLOSE
PROGRAM
AC/LOOP
ENTER
RUN
CLOSE
PROGRAM
AC/LOOP
ENTER
The Leader in Door Safety & Design
3
Press and
hold
PROGRAM
button until
display
changes to:
MESSAGE DISPLAY / COUNTER
Password
0
Press and
release the
Enter button.
Display
should
change to:
MESSAGE DISPLAY / COUNTER
LimitSet