Great Plains Industries FM-300U Manual do Proprietário - Página 9
Procurar online ou descarregar pdf Manual do Proprietário para Instrumentos de medição Great Plains Industries FM-300U. Great Plains Industries FM-300U 16 páginas. Electronic disc meter
Imprimir página
Your Actions
10. To end calibration, press and hold both buttons After you release the buttons,
for 3 seconds until you see "CAL End" message. the computer will resume
11. If you HAVE NOT dispensed any fluid, you can
exit calibration without changing the cal curve.
If the message "run 01" is showing and you
have not dispensed any fluid, hold both
buttons for about 3 seconds until you see a
"CAL End" message.
MAINTENANCE
This meter is virtually maintenance free.
It is important, however, that the nutator
disc moves freely.
To prevent drying of chemical on internal
assemblies, meters should be kept free
of chemical when not in use for extended
periods of time. Flush and clean after each
use to promote trouble-free operation.
Removal
WARNING
During meter removal, chemical may
spill. Follow the chemical manu-
facturer's safety precautions for
cleanup of minor spills.
1. Ensure all chemical is drained from
the meter. This could include draining
the hose, meter, and nozzle.
Notes
normal operations with the
new cal point(s) active.
After you release the buttons,
the computer will resume
normal operations and the
old curve (if you have entered
one in the past) is still intact.
2. Wearing protective clothing, loosen
the meter from fittings by hand.
CAUTION
To avoid damage to the housing, do
not use a wrench.
If the meter is not immediately installed
again, cap the hose end to prevent spills
and drying. The nozzle could be used for
this purpose. Flush the meter if it will not
be in use for more than two weeks.
Flushing
When removed or not in use for more than
two weeks, flush the meter to remove
chemical residue.
CAUTION
Do not submerge the meter.
If needed, clean the meter using Cleaning
instructions.
9