GREAT PLANES Gitabria Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Brinquedo GREAT PLANES Gitabria. GREAT PLANES Gitabria 20 páginas. Electrifly series

BUILD THE FUSELAGE

❏

1. Locate the two ABS landing gear supports. Glue

a landing gear support to each side of the fuselage in the

location shown.

❏

2. Remove the nine fuselage alignment crutches from

the surrounding foam. Note: Use a sharp hobby knife to cut

the crutch parts from the surrounding foam, trimming the tabs

ﬂ ush with the edges of the crutches.

❏

3. To prevent the parts from adhering to your building table,

place a piece of waxed paper, or the clear plastic bag the

parts came in, on your table. Use foam safe CA to glue the

nine alignment crutch feet to the alignment crutches. Make

sure the crutches and feet are ﬂ at against the building table

and that the crutches are perpendicular to the table.

❏

4. Insert the aft end of the horizontal fuselage into the

front of the vertical fuselage. Key the horizontal and vertical

fuselages together.

❏

5. On your building table, place the four bottom crutches

with the feet on them underneath the fuselage in the locations

shown. Crutch #1 is positioned in line with the bottom of the

windscreen. Crutch #2 is positioned at the ﬁ rst hole in the

side of the fuselage. Crutch #3 is positioned at the third hole

in the side of the fuselage. Crutch #4 is positioned at the ﬁ fth

hole in the side of the fuselage, just under the leading edge

of the stabilizer.

❏

6. Test ﬁ t the #1, #2 and #3 top crutches over their

corresponding bottom crutches. Install the ABS motor mount

onto the front of the ﬁ rewall, but DO NOT glue it in place at

this time. Check that all the crutches are seated against the

fuselage and the horizontal and vertical fuselages are keyed

together. Then, glue the top and bottom of crutches #1, #2

and #3 together by applying small amount of foam-safe CA to

the tabs of the crutches. Be careful not to glue the crutches

to the fuselage.

❏

7. Position the #4 top crutch over the corresponding #4

bottom crutch.