GREAT PLANES Gitabria Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Brinquedo GREAT PLANES Gitabria. GREAT PLANES Gitabria 20 páginas. Electrifly series

❏

8. Make sure the horizontal and vertical fuselages are keyed

together and the crutches are ﬂ at on your building table. Glue

the horizontal and vertical fuselages together by applying thin

foam-safe CA along the joint between the two. Be careful when

gluing around the crutches. DO NOT glue the crutches to the

fuselage. Allow the CA to cure for a few minutes before moving

the plane. The use of foam-safe accelerator will quicken the

curing of the CA, but use it sparingly. Excessive amounts of

accelerator can cause the CA to cure quickly, causing it to

get hot and melt the foam.

❏

9. On the left side of the fuselage, from the aft end, slide the

diagonal support with the hole in it, under the crutches. Align

the hole in the diagonal support with the hole in the horizontal

fuselage. Use foam-safe CA to glue the diagonal support at a

45 degree angle against the horizontal and vertical fuselages.

❏

10. Insert and glue the second diagonal support on the

right side of the fuselage. Make sure the aft end of the right

diagonal support is the same distance from the rudder hinge

line as the left diagonal support.

❏

11. Place the wing upside down on the building table.

Carefully turn the Citabria over and key the top of the fuselage

into the bottom of the wing. Note that the vertical ﬁ n will need

to hang over the edge of the building table. Check that #1, #3

and #4 crutches are ﬂ at on the building table. The #2 building

crutch should be ﬂ at on the wing. Check that the horizontal

and vertical fuselages are keyed together. Use foam-safe CA

to glue the bottom of the horizontal and vertical fuselages

together and the wing and vertical fuselage together.

Install the Wing Supports

❏

1. Locate the two ABS brace supports. There is a slot

located in the center of each wing. Glue the ABS brace

supports into the slots, perpendicular to the underside of the

wing. It is possible that, during manufacturing, some glue

may have gotten into the slot. If this has happened, DO NOT

FORCE the supports into the slot. Use a sharp hobby knife

to remove any excess glue.

❏

2. Locate the four long and two medium ABS brace

doublers

Note: For steps 3 through 5, DO NOT glue the parts until

told to do so.