Automated Logic BACview2 Manual do hardware - Página 3

Procurar online ou descarregar pdf Manual do hardware para Teclado Automated Logic BACview2. Automated Logic BACview2 5 páginas.

Imprimir página

Specifications

Power 24 VAC ± 10% 50-60 Hz at 350 mA,

8.4 VA supplied by the 14 conductor

ribbon cable (see Figure 2).

Software Requirements Screen files

must be transferred to the module

connected to the BACview

BACview

Programmer's Guide and the

BACview Programmer's Tutorial for further

information.

Module Interface 14-pin proprietary

auxiliary device port.

Hardware Requirements Use the

BACview

with any Exec 6.0 (or later)

control module with a 14-pin auxiliary

device port. For instructions on using the

BACview

, refer to the BACview

Guide.

Operating Temperature Range 32 - 120

°F, or 0 °C to 48.9 °C; 10 to 90% relative

humidity (non-condensing).

Protection Provides 12KV human

discharge model protection to the

encloser.

Listed By PAZX (UL 916), cUL C22.2

No.205-M1983.

Rear Mounting

Plate Screws

Revised 11/19/99 • BACview

. Refer to the

User's

Mounting Holes

Figure 2. Rear Mounting Plate

Hardware Guide

Mounting

The BACview

rear mounting plate (see

Figure 2) has four mounting holes and one

opening for the 14 conductor ribbon cable.

The rear mounting plate can be removed by

releasing the four screws on the sides and is

used as a template for mounting. There are

typically two different types of mounting,

Types I and II.

NOTE If this equipment is used in a manner

not specified by the manufacturer, the

protection provided by the equipment may be

impaired.

Type I Mounting

The BACview

can be mounted onto a panel

directly above the module it will

communicate with (see Figure 3 on page 4).

1. Remove the rear mounting plate screws

(see Figure 2 for location) from the

BACview

2. Remove the rear mounting plate from the

BACview

14 Conductor

Ribbon Cable

14 Pin TTL Connector

Rear Mounting

Plate Screws