Automated Pet Care Products LITTER-ROBOT Manual - Página 12
Procurar online ou descarregar pdf Manual para Produtos para animais de estimação Automated Pet Care Products LITTER-ROBOT. Automated Pet Care Products LITTER-ROBOT 16 páginas. Self-cleaning litter box
Também para Automated Pet Care Products LITTER-ROBOT: Manual (18 páginas), Manual do utilizador (19 páginas)
Imprimir páginaAutomated Pet Care Products, Inc.
Trouble Shooting
1. Home position not found
If the globe cannot find the home position, all three
lights on the Control Panel will blink at a rate of
once per second. Make sure the Litter-Robot is on a
level surface. If the condition persists, please call
Customer Service.
2. Cat Sensor fault
If the cat sensor switch is too sensitive, or if it is
dirty, the red light on the Control Panel will flash at
a rate of once per second. The globe will not rotate
until the cat sensor sensitivity is set properly, or the
switch is cleaned.
To adjust the cat sensor sensitivity, see the section
"Adjusting the Cat Sensor" in this manual.
To clean the cat sensor, follow the next steps.
40 W. Howard, Suite B-5, Pontiac, MI 48342
Toll Free: 877-250-7729 Fax: 248-253-1797
www.Litter-Robot.com
Locate the Cat
Sensor Switch
directly under the
waste drawer at the
front of the base.
19
Automated Pet Care Products, Inc.
After cleaning, press any of the three buttons on the
Control Panel to cancel the flashing red light. If the red
light continues to flash, call Customer Service for
assistance.
Please visit our web site for the latest Trouble Shooting
tips.
20
40 W. Howard, Suite B-5, Pontiac, MI 48342
Toll Free: 877-250-7729 Fax: 248-253-1797
www.Litter-Robot.com
Push down on the base
to separate the contacts
of the switch. Check for
contamination or litter
trapped between the
contacts.
With the switch held
open (by holding the
base down), spray some
WD40 between the
contacts.