Automated Pet Care Products LITTER-ROBOT Manuel - Sayfa 12

Evcil Hayvan Bakım Ürünü Automated Pet Care Products LITTER-ROBOT için çevrimiçi göz atın veya pdf Manuel indirin. Automated Pet Care Products LITTER-ROBOT 16 sayfaları. Self-cleaning litter box
Ayrıca Automated Pet Care Products LITTER-ROBOT için: Manuel (18 sayfalar), Kullanıcı Kılavuzu (19 sayfalar)

Sayfayı Yazdır

Automated Pet Care Products, Inc.

Trouble Shooting

1. Home position not found

If the globe cannot find the home position, all three

lights on the Control Panel will blink at a rate of

once per second. Make sure the Litter-Robot is on a

level surface. If the condition persists, please call

Customer Service.

2. Cat Sensor fault

If the cat sensor switch is too sensitive, or if it is

dirty, the red light on the Control Panel will flash at

a rate of once per second. The globe will not rotate

until the cat sensor sensitivity is set properly, or the

switch is cleaned.

To adjust the cat sensor sensitivity, see the section

"Adjusting the Cat Sensor" in this manual.

To clean the cat sensor, follow the next steps.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Locate the Cat

Sensor Switch

directly under the

waste drawer at the

front of the base.

Automated Pet Care Products, Inc.

After cleaning, press any of the three buttons on the

Control Panel to cancel the flashing red light. If the red

light continues to flash, call Customer Service for

assistance.

Please visit our web site for the latest Trouble Shooting

tips.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Push down on the base

to separate the contacts

of the switch. Check for

contamination or litter

trapped between the

contacts.

With the switch held

open (by holding the

base down), spray some

WD40 between the

contacts.