Dynacut MDE Manual de operação - Página 12
Procurar online ou descarregar pdf Manual de operação para Sistemas de lubrificação Dynacut MDE. Dynacut MDE 17 páginas. Minimum quantity lubrication system for external lubrication
Imprimir página
Initial filling
The lubricant reservoir must be depressurised before filling the lubricant.
For the first use of the system, it is recommended to fill the lubricant reservoir before
connecting it to the compressed air and electrical power supply.
If the system is already connected to the compressed air supply, it must be ensured that the
lubricant supply tank has been depressurized before filling.
To make the lubricant reservoir unpressurised, first disconnect the system from the
compressed air supply by disconnecting the system from the air line or closing the main valve
(10 Figure 2).
When the main valve is closed, the tank pressure is relieved via this valve.
Check that the print has been completely removed. The manometer must show the value
'zero'.
If you are sure that the pressure has been completely relieved, you can now open the filling
plug (14 Fig. 2) and fill the lubricant.
Attention:
Only suitable minimum quantity lubricants may be used as lubricants.
Please note that we cannot assume liability for damage caused by the use of
unsuitable lubricants.
Be sure to close the filler plug after filling.