Dynacut MDE Kullanım Kılavuzu - Sayfa 12

Yağlama sistemleri Dynacut MDE için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Dynacut MDE 17 sayfaları. Minimum quantity lubrication system for external lubrication

Sayfayı Yazdır
Dynacut MDE Kullanım Kılavuzu

Initial filling

The lubricant reservoir must be depressurised before filling the lubricant.
For the first use of the system, it is recommended to fill the lubricant reservoir before
connecting it to the compressed air and electrical power supply.
If the system is already connected to the compressed air supply, it must be ensured that the
lubricant supply tank has been depressurized before filling.
To make the lubricant reservoir unpressurised, first disconnect the system from the
compressed air supply by disconnecting the system from the air line or closing the main valve
(10 Figure 2).
When the main valve is closed, the tank pressure is relieved via this valve.
Check that the print has been completely removed. The manometer must show the value
'zero'.
If you are sure that the pressure has been completely relieved, you can now open the filling
plug (14 Fig. 2) and fill the lubricant.
Attention:
Only suitable minimum quantity lubricants may be used as lubricants.
Please note that we cannot assume liability for damage caused by the use of
unsuitable lubricants.
Be sure to close the filler plug after filling.