Hiboy ECOM 14 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Scooter Hiboy ECOM 14. Hiboy ECOM 14 15 páginas. 14" electric scooter
Também para Hiboy ECOM 14: Manual do utilizador (11 páginas)

Imprimir página

4. Assembly and Set up

Before you begin: Remove contents from box. Remove the separators that protect the components from damage during shipping.

Inspect the contents of the box for scratches in the paint, dents, or kinked cables that may have occurred during shipping. Because

the electric scooter was partially assembled and packed at the factory, there should not be any problems, even if the box has a few

scars or dents.

MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.

Hiboy recommends assembly by an adult with experience in bicycle mechanics.

Attaching the Handlebars

Unfold the Scooter

Required Tools: 5 mm Allen Wrench (included)

Open the folding lock

1. Loosen the screw on Top of T-tube

2. Put the handle bar on(the thread

part should be in the middle)

Need Help? Please search "Hiboy us" on Youtube website to ﬁnd our Channel. You can watch the Installation video

of ECOM 14. Or contact Hiboy after-sale team by email: [email protected].

3. Tighten the screw

Note:Please lock the brake cables with

the black latch on the T-tube (to prevent

the cables clutter)

Attaching the Front Wheel

Required Tools:16mm Wrenches*2(Included)

1.Remove axle nuts (A) and washers (B)

4.The drum brake is aligned with the

middle of the front wheel

from the axle bolt (C)

2.Pull axle bolt(C) out of the front fork

Note: the drum brake cable should be

placed in the front fender connecting rod

3.Discard the black latch(D)

Need Help? Please search "Hiboy us" on Youtube website to ﬁnd our Channel. You can watch the Installation video

of ECOM 14. Or contact Hiboy after-sale team by email: [email protected].

5.Insert the front wheel into the

front fork

6.Insert the axle bolt (C) into the middle

hole of drum brake, tighten the axle nuts

(A) and washers (B) on two sides