ADEMCO 5707 Manual de instruções de instalação - Página 2
Procurar online ou descarregar pdf Manual de instruções de instalação para Alarme de fumo ADEMCO 5707. ADEMCO 5707 12 páginas. Smoke detector with built-in wireless transmitter
Imprimir página
INSTALLATION
PROCEDURE
Release the detector's mounting bracket by pressing the tab marked PRESS in
the detector's base (see Fig.1 for location of the tab).
Note the manner in which
the bracket was attached to the detector base, then put the mounting bracket
aside temporarily.
The mounting bracket also serves as the battery compartment
cover, but do not install the batteries yet..
Dip
Switch Settings
The detector's
DIP switches
must be set for the assigned
House
ID and
Transmitter
ID numbers before the unit will operate with the wireless system.
To gain access to the PC board
and
DIP
switch,
insert
the
blade
of a small
screwdriver
into the opening in the detector
base (see Fig. 3 for location)
and twist. This will release the
main
cover
which
will
then
swing away, providing
access
to the interior
of the detector,
as shown in Figure 2. Set the
switches as required, using the
DIP switch table provided.
When
DIP switches
are set,
swing
cover
down
firmly
to
secure.
DIPSWITCH
Figure 2. Interior
View of Smoke Detector
SWITCHES 1-5 ARE USED FOR S~lNG
HOUSE I.D. NUMBERS 1-31 (TO
SE7 'W, POSMON AILS SWITCHES .ON-). SWTCtiES 6.7 AND 8 ARE
USED FOR SE7TING TRANSMITTER I.D. NUMBERS 4S-55 AS SHOWN.
HOUSE I.D.
TRANSMITTER I.D
K!!!ml=:==m
SHCWN SET FoR HOUSE I D ,31
TRW4SMIT7ER I.D.: 4S
-2–