Automotive Tazer DT Manual - Página 4

Procurar online ou descarregar pdf Manual para Acessórios para automóveis Automotive Tazer DT. Automotive Tazer DT 9 páginas. Programmer/light show

Wait about 60 seconds AFTER the dash goes dark, then re-enter.

this twice.

The setup menu is accessed with the ignition ON but engine NOT running.

The menu items are listed in the order in which they will display.

Light Show

: Though this is not a setting, it's in the settings menu so that the light shows can be

activated also when the engine is off – this will work in ACC mode as well.

Clear CELs

: Though this is not a setting, if selected, this will clear a check engine light and diagnostic

codes stored in the PCM, TCM, ABS, and AWD modules.

Marry/Unmarry:

To advance to any of the vehicle settings, you will first need to "Marry" the Tazer to

the vehicle. Simply select this option, and the Tazer will download your RAM's current (stock) settings.

This takes approx. 15 seconds, do not disturb this process. Once complete, you will be able to advance

to the settings choices. Select "unmarry" to return the vehicle to stock. A couple cycles of the vehicle

being started then allowed to sleep may be needed for all setting changes to take place. Any changes to

the radio settings will require a "full reboot" to be selected.

Submenus:

Once married, you can advance though several sub-menus. Select a submenu using the

method described above, which depends on vehicle type.

Submenu Perf – sets the performance-based options:

Set Tire Size:

Use this setting to change the calibration for tire size. Use the left arrow and cruise +/-

buttons to raise or lower the value, then select it (left arrow and cruise on/off) to save the new setting.

Set Gear Ratio

: Use this setting to change the calibration for axle gear ratio. Use the left arrow and

cruise +/- buttons to raise or lower the value, then select it (left arrow and cruise on/off) to save the

new setting.

Set Transfer Case LOW ratio

: Use this setting to change the calibration for 4LOW gear ratio. Use the

left arrow and cruise +/- buttons to raise or lower the value, then select it (left arrow and cruise on/off)

to save the new setting.

Submenu Tire– sets TPMS options:

Set TPMS

: Turn the tire pressure monitoring system on or off.

Set Tire Pressures Front/Rear:

Change the TPMS warning pressures. Use the left arrow and cruise +/-

buttons to raise or lower the value, then select it (left arrow and cruise on/off) to save the new setting.

Submenu Radio – sets the radio-based options: