Automotive Tazer DT Manual - Página 3

Procurar online ou descarregar pdf Manual para Acessórios para automóveis Automotive Tazer DT. Automotive Tazer DT 9 páginas. Programmer/light show

* Use of extra video inputs requires wiring video source(s) to radio.

required, sold separately. Some features are included yet not fully tested as the platform is so

new.

Functions) only work when installed. The Tazer DT will go to sleep by itself, 30 seconds after the RAM

shuts down.

This section explains how to use the Tazer to change the vehicle settings for

feature activation.

Navigating the menus: For all functions involving the dash (EVIC) display, the EVIC screen first needs to

be in a state where it's showing the AUDIO screen. Use the left and up/down arrows to set the EVIC

display like this. One the display is in this state, press and hold the steering wheel LEFT ARROW, and tap

the Cruise "CANCEL" button to enter the settings menu. Pressing LEFT ARROW and CANCEL will advance

through the menu items. To change/select a setting, press and hold LEFT ARROW and tap the Cruise

"ON/OFF" (center) button. Advance through the menu slowly. You can exit the menu quickly and safely

by holding the left arrow and pressing the cruise RES button. If you made any changes in the setup

menu that affect the radio, be sure to scroll to "full reboot?" and "select" it

IMPORTANT NOTE:

Some settings require two sleep/wake cycles.

this is to turn the ignition off, open and close the driver's door.

Installation

Installation is a matter of unplugging the SGW module

above the OBD2 diagnostic connector and plugging the

Tazer DT in its place. Simply locate the SGW and

unplug its two connectors by pressing the tab with

your index finger and gently

pulling straight down on the

wires. Plug those two

connectors into the Tazer DT.

The Tazer DT typically should

be left installed unless the

RAM is going for dealer

service. It does not need to be

plugged in for any of the

features in the Vehicle Settings

to remain operational. The Tazer DT is intended to

be left plugged in, as many of its features (Live

Special adapter harness

The quickest way to do