Automotive Tazer DT Manual - Página 7

Procurar online ou descarregar pdf Manual para Acessórios para automóveis Automotive Tazer DT. Automotive Tazer DT 9 páginas. Programmer/light show

TurnCAM:

If enabled, will automatically turn on the backup camera if the turn signals are being used.

When this is enabled, In-motion nav will be disabled.

AutoFold:

If enabled, will automatically retract and extend the power folding mirrors (if equipped)

with ignition.

Video:

If selected, will turn on backup camera input.

0-30 Timer: When the vehicle is stopped, this display will change to "start 30". As soon as the vehicle

starts moving, the display will change to "go to 30" and the timer starts. When the vehicle reaches

30MPH, the time will be displayed.

0-60 Timer: When the vehicle is stopped, this display will change to "start 60". As soon as the vehicle

starts moving, the display will change to "go to 60" and the timer starts. When the vehicle reaches

60MPH, the time will be displayed.

Display Tazer Firmware Revision: Displays the Tazer's current firmware version: "TZ DT: x.x.x." (ie

"TZDT:18.0.1")

Non-Menu Live Functions

The Tazer has other live functions that are not accessed via a menu.

Light Shows:

The Tazer comes pre-configured with 6 light shows out of the box, plus 3 "make your own" light shows

that you can configure with the ZPU utility. There are two ways to control the light shows on the Tazer:

Keyfob: The light show can be turned on by pressing unlock-unlock-lock-unlock from the keyfob. This

will start the first light show in the sequence (depending on which show it's configured to start with).

Pressing unlock again will advance to the next enabled show. Pressing lock will turn off the light shows.

You may lock the vehicle while the shows are on by pressing the button on the door handle or using the

key.

Dash Menu: You can start the show by setting the dash to "Audio" mode, then press the left arrow and

tap cruise CANC button. "Lightshow?" will display on the dash. Hold left arrow and tap cruise on/off

(center) button to turn on the first light show in the sequence. Again to advance to the next show. Exit

the menu (left arrow and CANC) to turn off the show.

Cooldown Mode: With the ignition on but engine not running, press the right arrow and cruise cancel

button at the same time to turn the engine fan on High. They will also turn off automatically if the

battery voltage drops below 11V.