Automotive Tazer DT Manual - Página 8

Procurar online ou descarregar pdf Manual para Acessórios para automóveis Automotive Tazer DT. Automotive Tazer DT 9 páginas. Programmer/light show

Winch Mode: With the engine running, press the left arrow and cruise RES buttons at the same time.

The engine will rise to 2000 RPM. There may be a few seconds delay before it changes. It will NOT raise

if you touch the accelerator pedal, and will cancel if you do.

Line Lock: While in 2WD, press and hold the left arrow and cruise set(+) buttons. Continue to hold and

pump the brakes twice, firmly. The RAM will stay held using only the front brakes while you press on

the accelerator to do a burnout. "Brklock:frt" will be displayed in the cluster.

Rock Crawl

: Press and hold the left arrow and cruise set(-) button, and pump the brakes

(patent pending)

twice. The RAM will hold using all four brakes while you can work the pedals to apply torque, and

release the buttons when you're ready to move. "Brklock:all" will be displayed in the cluster.

Full traction control disable: Press and hold the traction button for 5 seconds to fully disable TC and

ABS. Shut off and re-start RAM to re-enable.

Force Backup camera: Double tap the "mute" button to switch to backup camera (8.4")

Button Remap: This function allows the assignment of "hotkeys" for quick access to some of the Tazer's

functions. The cruise +/-/RES may be used for this function. While the dash is in Audio mode, press and

hold the RIGHT arrow and press the button you'd like to remap. The choices are: Any of the 8 light

shows, backup cameras, line lock, rock crawl, TC kill, Cooldown, Front/Rear/Front+Rear Lockers,

SwayKill. Keep in mind that not all functions pertain to all vehicles. These remap buttons will only

program and operate while Cruise Control is OFF. When Cruise is on, they will operate as normal cruise

control buttons. For TC Kill, a vehicle restart is required to bring the system back to normal. For

Lockers, the normal Locker off button disengages the lockers.

Windows from Keyfob: Press the unlock key 5 times and the front windows will roll down. Press Lock 5

times and they will roll up. Be sure that the vehicle is in view when rolling the windows from the keyfob.

Partial Reboot:

Press left arrow and cruise RES with the ignition set to RUN and engine is not running,

and the Tazer will reset several systems including the PCM (engine adaptives), RF Hub, Instrument

cluster, ABS, BCM.

Configuration (Light shows)

Configuration of the Tazer is accomplished by using the supplied USB cable connected to a PC, using the

ZPU Programming Utility. The ZPU User Guide explains how to install ZPU and how to perform firmware

updates. The Tazer DT does not need to be connected to a vehicle in order to use ZPU.

Please see the accompanying "Light Show Configuration Guide" to configure your Tazer JL's light show

options.