Cell2 SDF104H Manual de instalação e operação - Página 6

Procurar online ou descarregar pdf Manual de instalação e operação para Amplificador Cell2 SDF104H. Cell2 SDF104H 12 páginas. Siren amplifier

Power Wire Terminal Block (Connector A)

● Power +VDC & -GND

1. Connect to the positive (+) battery terminal. Fuse each wire independently @35 Amps (user-supplied).

DO NOT install these fuses until the wiring for the entire system has been completed.

2. Connect to the vehicle's chassis ground (typically adjacent to the battery).

3. Plug the Connector A into the siren amplifier.

Control Wire Harness (Connector B)

● Ignition Activation (IGN) input

Apply +VDC continuously to RED wire to enable the siren system. Connect this wire to a positive

circuit controlled by the vehicle ignition switch to allow the siren amplifier to be turned on & off together.

The system does not operate without this Ignition Activation. DO NOT directly connect this wire to the

battery as this may drain battery.

● SW1 Output

Connect to auxiliary device power up to 5 Amps max. or use as Lightbar function activation switch.

● SW2 Output

Connect to auxiliary device power up to 5 Amps max. or use as Lightbar function activation switch.

● SW3 Output

Connect to auxiliary device power up to 5 Amps max. or use as Lightbar function activation switch.

● SW4 Output

Connect to auxiliary device power up to 5 Amps max. or use as Lightbar function activation switch.

● Speaker Out

Connect the BLUE (SPK+) and BROWN (SPK-) wires to one 100W 11-ohm impedance speaker.

● Radio Re-broadcast

Connect WHITE and GREY wire to the speaker output of a radio console.

● Horn Ring Transfer (HRT) input

Apply +VDC continuously to PINK wire for Air Horn tone.

- 4 -