909 254CMS Manual de instruções - Página 15

Procurar online ou descarregar pdf Manual de instruções para Serra 909 254CMS. 909 254CMS 19 páginas. 1800w 255mm (10") single bevel laser guided compound mitre saw

Imprimir página

rotating blade guard (5) is

positioned over the upper

fixed blade guard (4) it

is possible to access the

blade bolt (Fig. h).

7. Hold the rotating guard (12)

up and press the spindle

lock button (18) (Fig. i).

Rotate the blade until the

spindle locks.

8. Use the 6 mm hex key provided to loosen and remove

the blade bolt. (Loosen in a clockwise direction as the

blade screw has a left hand thread) (Fig. j).

9. Remove the flat washer

and outer blade washer

and the blade.

10. Wipe a drop of oil onto the

inner blade washer and

the outer blade washer

where they contact the

blade.

11. Fit the new blade onto the

spindle taking care that

the inner blade washer sits behind the blade (Fig. k).

CAUTION.

To ensure correct blade rotation, always install

the blade with the blade teeth and the arrow printed on

the side of the blade pointing down. The direction of blade

rotation is also stamped with an arrow on the upper blade

guard.

12. Replace the outer blade

washer (Fig. l).

13. Depress the spindle

lock button (18) and

replace the flat washer

and blade bolt.

14. Use the 6 mm hex key

to tighten the blade bolt

securely (tighten in an

anti-clockwise direction).

15. Lower the blade guard, hold the rotating lower blade

guard (5) and blade bolt cover (19) in position and

tighten the fixing screw (Fig. m).

16. Replace the guard retraction arm and secure onto the

rotating blade guard (Fig. n).

17. Check that the blade guard operates correctly and

covers the blade as the saw arm is lowered.

18. Connect the saw to the power supply and run the blade

to make certain that it is operating correctly.

Cross-cutting

A crosscut is made by cutting

across the grain of the

workpiece. A 90º crosscut is

made with the mitre table set

at 0º (Fig. o). Mitre crosscuts

are made with the table set at

some angle other than zero.