909 254CMS Manual de instruções - Página 16

Procurar online ou descarregar pdf Manual de instruções para Serra 909 254CMS. 909 254CMS 19 páginas. 1800w 255mm (10") single bevel laser guided compound mitre saw

Imprimir página

1. Pull on the release knob (2) and lift the saw arm (1) to its

full height.

2. Loosen the mitre lock (15).

3. Rotate the mitre table (12) until the pointer aligns with

the desired angle.

4. Retighten the mitre lock (15).

WARNING.

Be sure to tighten the mitre lock before making

a cut. Failure to do so could result in the table moving

during the cut and cause serious personal injury.

5. Place the workpiece flat on the table with one edge

securely against the fence (11). If the board is warped,

place the convex side against the fence. If the concave

side is placed against the fence, the board could break

and jam the blade.

6. When cutting long pieces of timber, support the opposite

end of the timber with the side support bars, a roller stand

or a work surface that is level with the saw table.

7. Use the clamp assembly (30) to secure the workpiece

wherever possible.

8. It is possible to remove

the clamp assembly (30)

by loosening the clamp

assembly lock (23) and

moving it to the other side

of the table. Make sure the

clamp assembly lock is

tight before using the clamp

(Fig. p).

9. Before turning on the saw,

perform a dry run of the cutting operation to check that

there are no problems.

10. Hold the operating handle (3) firmly and squeeze the

switch trigger (16). Allow the blade to reach maximum

speed and slowly lower the blade into and through the

workpiece.

Pull the guard release lever to allow the head to be

lowered.

11. Release the switch trigger

(16) and allow the saw

blade to stop rotating

before raising the blade

out of the workpiece.

Wait until the blade stops

before removing the

workpiece. (Fig. q).

Bevel cut

A bevel cut is made by

cutting across the grain of

the workpiece with the blade

angled to the fence and mitre

table. The mitre table is set at

the 0° position and the blade

set at an angle between 0º

and 45º (Fig. r).

1. Pull on the release knob (2)

and lift the saw arm to its

full height.

2. Loosen the mitre lock (15).

3. Rotate the mitre table (12) until the pointer aligns with

zero on the mitre scale (13).

4. Retighten the mitre lock (15).

WARNING.

Be sure to tighten the mitre lock before making

a cut. Failure to do so could result in the table moving

during the cut, causing serious personal injury.

5. Loosen the bevel lock (7). Move the saw arm (1) to the

left or right to the desired bevel angle (between 0º and

45º). Tighten the bevel lock (7).

6. Place the workpiece flat on the table with one edge

securely against the fence (11). If the board is warped,

place the convex side against the fence. If the concave

side is placed against the fence, the board could break

and jam the blade.

7. When cutting long pieces of timber, support the ends

of the timber with the side bars, a roller stand or a work

surface that is level with the saw table.