DCB SE-6600 Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para Hardware de rede DCB SE-6600. DCB SE-6600 4 páginas. Serial encrypter

In this configuration, the communications between the two PCs are taking place "in the clear",

without encryption enabled. (The "Encrypting" LEDs on the SE-6600 units will be off.) The

next step will turn link encryption on.

10: With the LAN cable still connected to SE-6600 B, open the web browser and enter

http://192.168.1.2

(the new IP address from Step 7). Click on Cipher Config from the menu of

SE-6600 B to display the screen shown in Figure 3, and this time, click on the red rectangle

which reads, "Enable Block Mode Cipher".

This not only activates the encryption on the SE-

6600 B unit, but also sends a message to SE-6600 A to do the

same. An Enabling Block Mode

Cipher screen will appear, with a message to wait while the action takes place. (Note that SE-

6600 A could have been used to send the message to SE-6600 B instead.)

Now the "Encrypting" LEDs on the SE-6600 units will be lit, and the terminal-to-terminal

communications described in Step 9 should once again be possible.

Clicking on Port Activity from the menu displays a screen similar to that shown in Figure 6

below. Whenever either PC sends terminal messages to the other, the Serial counters will

increase, but the Network counters will also increment due to the SE-6600 units communicating

with each other, even in the absence of terminal activity.

Figure 6 – SE-6600 Port Activity Screen, Showing Byte Counters