Emerson FB1200 Manual de substituição - Página 15

Procurar online ou descarregar pdf Manual de substituição para Acessórios Emerson FB1200. Emerson FB1200 18 páginas. Flow computer coin cell battery field
Também para Emerson FB1200: Manual de substituição de placas de terminação no terreno (18 páginas), Manual de substituição no terreno (14 páginas), Manual de substituição no terreno (20 páginas), Manual de substituição no terreno (8 páginas), Manual de substituição no terreno (8 páginas), Manual de substituição (8 páginas)

FB1100/FB1200 Flow Computer Termination Board Field Replacement Guide

For the terminal block you want to replace, make sure you note which wire goes to which

terminal. If they aren't labeled, you should label them, or take a digital photo so you know

which wire goes to which connector of the terminal block.

Place your fingers on each of the short sides of the terminal block and gently rock it back

and forth so it pops out of the termination board.

10.

Use a flat head screwdriver to loosen the screw for each wire coming into the old terminal

block. Slide the same wire into the identical position on the new (replacement) terminal

block and tighten the screw to hold it in place. Repeat for each wire.

11.

Repeat steps 8 through 10 for each terminal block you want to replace.

12.

If you have an internal battery, you can re-connect it now, and put the HMI module back

on. To replace the HMI module, line up the printed circuit board (PCB) with the slot on the

back of the replacement module and gently press the new HMI module on. Tighten the

four captive fastening screws with a torque of 6 in-lbs (0.7 N-m).

D301820X012

November 2020