DDC Sentry VOIP V2 Manual - Página 13

Procurar online ou descarregar pdf Manual para Telefone DDC Sentry VOIP V2. DDC Sentry VOIP V2 20 páginas.

PROGRAMMING (Phone Number menu)

Button Call Number Assignment

The DDC_VoIP phone can be configured with up to 16 buttons, each may be assigned to dial

a different telephone number.

Click on the Button Call Number Assignment radio button and input the access code, then

click 'Enter'.

Each Button, (if fitted) may be set to dial a different phone number. The Name field giving

to each input is for internal reference only and is not required.

The phone number may be an IP address/port number, ie 192.168.1.123:5060.

Sometimes, it may be required to dial this number without each DTMF tone played out of

the speaker, especially so, for long phone numbers like an IP address, to enable silence

dialling click Yes to the option Dial numbers silently in the System section, see page 9.

Special commands within the phone number,

The DDC_VoIP unit can be configured to connect to a PSTN/PBX via a ATA. In this scenario the

unit calls the ATA and then, on answer, the DDC_VoIP phone then dials the PBX number.

To archive this, enter the first part of the number (the section that call the ATA) followed by a pipe

character '|', and the PBX telephone number to call. (the PBX number may include a pause by

adding a comma ','). Example, if the ATA number is 1234 and the PBX number is 9,91234567, then

you would enter 1234|9,91234567.

Note that the ATA number can be loaded in the Dial Prefix location, if all buttons calls are made

via the ATA, then set the Dial Prefix to '1234|'.

Note that the ATA number could well be an IP address.

Dallas Delta Corporation Pty.Ltd.

Page 13