highwood Weatherly Manual de montagem - Página 2

Procurar online ou descarregar pdf Manual de montagem para Mobiliário de exterior highwood Weatherly. highwood Weatherly 2 páginas. Porch swing

Imprimir página

Before you start

This assembly can be done by one person alone,

however it is much easier when two people work as a

team. Also, do not over-tighten bolts, but ensure that a

firm and secure connection is made in every instance to

avoid excess movement in joints.

Step 1

Connect Swing Back to Swing Seat

Position and hold the Swing Back (A) and Swing Base (B)

together, and attach one side using two 2-1/4" Carriage Bolts (D)

and two Flange Nuts (G) as shown in Image #1 below.

Note: Holes are pre-drilled for the Carriage Bolts to pass through,

but use a hammer to firmly tap the bolt end several times so that

the square neck sinks into the highwood

Repeat for other side.

Image #1

Connect the two center braces using two 2-1/4" Carriage Bolts

(D) and two Flange Nuts (G) as shown in Image #2 below.

Image #2

For information on Care and Cleaning your highwood

Visit our Website and Facebook page to see more highwood

material.

www.highwood-usa.com • www.facebook.com/highwoodUSA

Step 2

Attach Arm Rests to Swing Seat and Back

With the swing resting on the swing back, position and hold Arm

Rest (C) to the assembled swing and attach the front support using

one Open-Eyed Eyebolt (F) and one 2-1/4" Carriage Bolt (D).

Note: Holes are pre-drilled for the Carriage Bolts to pass through,

but use a hammer to firmly tap the bolt end several times so that

the square neck sinks into the highwood

From the inside of the swing base, attach one Flange Nut (G) to

the Carriage Bolt to secure. Next, attach one Flat Washer (H) and

Lock Nut (I) to the Eye Bolt making sure the Eyebolt opening

faces down when fully tightened.

Finish attaching the Arm Rest to the Swing Back using one 3"

Carriage Bolt (E) and one Flange Nut (G).

Both steps are shown in Image #3 below.

Repeat for other side.

G H + I

Image #3

Step 3

Attaching the Swing Chains

Using the supplied 7' Stainless Steel Chain (J), attach one end to

the eye bolt (F) and the other end to the pre-installed eye bolt on

the swing back as shown in Image #4 below.

Attach the Chain Connector (L) to center point of the chain and to

the 2' Stainless Steel Chain (K) as shown in Image #5.

Repeat on other side.

pre-Installed

Image #4

product visit www.highwood-usa.com/care.html

Image #4

material.

Image #5

products!