AFL IDEAA 144F Manual de instruções de instalação - Página 9

Procurar online ou descarregar pdf Manual de instruções de instalação para Invólucro AFL IDEAA 144F. AFL IDEAA 144F 14 páginas.

IDEAA SPLITTER MODULE INSTALLATION

MOUNT IDEAA SPLITTER MODULE

1. Using local engineering practices, determine the

location of the IDEAA Splitter Module to be installed

within the IDC.

2. Using the provided hex-head screws, attach the

mounting bracket to the bottom side of the IDEAA

Splitter Module. (Figure 14)

3. Install the IDEAA LGX-118 Rack Mount Bracket into

the LGX-118 mounting fixture by pressing in the two

nylatch plungers. (Figure 16)

4. Repeat Steps 1 – 3 for each IDEAA Splitter Module

to be mounted.

ACTIVATE IDEAA SPLITTER MODULE

An IDEAA Splitter Module that has been mounted into

the IDC is not active until it has been connected to the

Input Field.

Caution: When working with fiber optics, do

not look directly into the end of the fiber cable

or adapter port. A power meter may be used to

determine if the cable or port is dark. Or use

locally accepted fiber optic safety practices.

1. Use local accepted practices to clean the connector

end face at both ends of the jumper provided with the

IDEAA Splitter Module.

2. Plug the jumper cable into the black input port on

the IDEAA Splitter Module. Use the foam fiber relief

to route the jumper cable to the fiber routing section

of the IDC. (Figure 16)

Note: When mounted on the LGX-118 mounting

fixture the black input port will be located in the

bottom right corner of the module adapter field.

INSTALLATION INSTRUCTIONS

IDEAA

Interior Distribution Cabinet

Figure 14

Figure 15

Figure 16

Specifications are subject to change without notice.

Nylatch Plunger