Dea 124RR Instruções e avisos - Página 7

Procurar online ou descarregar pdf Instruções e avisos para Painel de controlo Dea 124RR. Dea 124RR 11 páginas. Control board 24v for gate automation operating

Imprimir página

Operating instructions and warnings

Channel selection and linking on the transmitter

The built-in receiver can control both the start input and the pedestrian one. By setting the correct value

of the parameter "P009 Selection and linking of channels" it is possible to decide which key of the tran-

smitter will activate each input.

If you check on the "working parameters" table you will realize that the P009 parameter allows you to

choose among 16 different combinations. If, for instance, you attribute value "3" to the parameter P009,

all memorized transmitters will activate the start input through the CH1 and the pedestrian input through

CH4. Please refer to chapter "8.4 Personalization of working parameters" in order to select your own

combination.

8.4

Personalization of working parameters

Instructions

The control board is ready to receive instructions

Scroll down the parameters until you visualize the one you wish to set (ex. P010)

Confirm! The display shows the set parameter value

Increase or decrease the value until you reach the value you wish to define

Confirm! The display shows again the parameter

Scroll down the parameters until you visualise "----". The control board awaits

further instructions

The automation is now ready to work according to the new working parameters.

8.5

Resetting of default parameters (p.007)

DEA 124RR control board software includes a reset procedure to restore default values (the one set by

the maker) of all settable parameters. The value originally set for each parameter is shown in the "working

parameters table". In case you should reset all values and restore all default values, proceed as follows:

Instructions

The control board is ready to receive instructions

Scroll down the parameters until you visualize P007

Confirm! The control board awaits a further confirmation

Confirm by pressing on the OK button. The procedure starts

All parameters are now set at their original value

Scroll down the parameters until you visualise "----". The control board awaits

further instructions

8.6

Safety devices

DEA 124RR control board allows fitters to set up installations that truly comply with European regula-

tions concerning automated garage doors and gates. More specifically, this control board allows you to

comply with the limits set by the same regulations as to impact forces in case of collision with obstacles.

DEA 124RR control board is equipped with a built-in anti-crush safety device that, associated to the

possibility of tuning up the motors' speed, allows you to comply with the limits imposed by the above

mentioned regulations in most installations.

In particular, you can adjust the anti-crush safety device sensitivity by properly setting the value assi-

gned to the following parameters (see also "8.4 Personalization of working parameters "):

•P014 motor 1 force in opening: from 30 (min. force, max sensitivity) to 100 (max force, neutralized sensitivity)

•P015 motor 1 force in closing: from 30 (min. force, max sensitivity) to 100 (max force, neutralized sensitivity)

In case the gate structural features do not allow you to comply with the above force limits, it is possible

to use external safety devices inputs (terminal no. 12). SIC inputs can be configured by properly setting

parameter no. 18:

•P018= 0 "rib" mode functioning: when the input is activated the movement direction of the motors is inverted.

•P018=1"photoelectric barriers" mode functioning: when the input is activated, the motor stops.

Function

Display