AGT INDUSTRIAL AGT-RC72 Manual do produto - Página 14

Procurar online ou descarregar pdf Manual do produto para Cortador de escova AGT INDUSTRIAL AGT-RC72. AGT INDUSTRIAL AGT-RC72 19 páginas. Skid steer brush cutter

Imprimir página

Handling safety

First Time Use Procedure

Before operating the brush cutter, check the skid steer's hydraulic oil level and add oil if

necessary.

If you are operating the brush cutter ensure the case drain hose is properly attached to the

prime mover's case drain connection. DO NOT operate this attachment WITHOUT the

case drain hose attached. Excessive hydraulic pressure will blow out the seals.

Ensure that hydraulic hoses are securely locked to the skid steer hydraulic couplers

before starting the brush cutter.

After starting skid steer, lift attachment 36 inches off the ground surface:

With the skid steer engine RPMs just above idle, activate the skid steer's auxiliary

hydraulic system.

1.Swing the boom to the right using the skid steer's auxiliary electrical controller, or by

holding down the RT button on the paddle controller.

2.Tilt the cutter up by holding down the UP button on the paddle controller. Then tilt in

the opposite direction by holding down the DOWN button.

3.Swing the boom to the straightforward position and tilt the cutter to the level position

using the buttons on the paddle controller.

4.Allow the cutter to run for 30 seconds to purge air from the system, then turn off

hydraulic flow to the brush cutter and allow it to come to a complete stop.

5.Lower the brush cutter to the ground, set parking brake, shut off the skid steer's engine

and exit the operator's compartment.

6.Check the skid steer's hydraulic oil level, add oil if necessary.