Airflow 200G-XX Manual do Proprietário - Página 3

Procurar online ou descarregar pdf Manual do Proprietário para Ventilador Airflow 200G-XX. Airflow 200G-XX 12 páginas. Builder’s choice gallery edition

Imprimir página

Unpacking

Before assembling and installing your ceiling fan, remove all

parts from the shipping cartons and check them against the

parts listed here. Before discarding packaging material, be

certain that all parts have been removed.

Be sure to only use genuine Airflow blades. The blade shrink

wrap holds five blades of matched weight. If more than one

fan is being installed, be sure not to mix blade sets.

ALLEN SET SCREW

⁄

-20 x

⁄

(PRE-INSTALLED)

Prepare for fan installation as follows:

Step 4. Route the wires from the motor through the canopy,

then the Perma • Lock™ downrod and ball assembly.

TIP: The downrod has a tapered thread

that is designed to lock completely when

correctly installed.

Step 5. Using the provided Allen wrench, loosen the set screw

several turns to allow installation of the downrod. Thread the

downrod into the motor coupling until it stops turning, this

will take at least four and a half full turns.

Step 6. Securely tighten the set screw with the provided Allen

wrench to ensure safe operation of your fan.

CAUTION: Failure to fully lock in the down-

rod before securely tightening the allen set

screw may cause the fan to separate from

the downrod during normal operation!

GETTING STARTED

NOTE: Only one set of blade holders is supplied. Depending on

the fans and series, there are three different mounting

procedures.

FAN INSTALLATION

PERMA • LOCK™ HARDWARE

3mm

ALLEN WRENCH

FAN PREPARATION

CAUTION: When removing the shrink wrap,

be careful not to scratch the blades.

GROUND

WIRE

TAPERED

THREAD

ALLEN

SET SCREW

UILDER

HOICE

ALLERY

DITION

DOWNROD & BALL

ASSEMBLY

MOTOR

WIRES

BLUE

WIRE

CANOPY

DOWNROD

MOTOR

COUPLING

™