Gammaflux GLC 2k Manual de configuração

Procurar online ou descarregar pdf Manual de configuração para Controlador Gammaflux GLC 2k. Gammaflux GLC 2k 4 páginas.

GLC 2k

Advanced Setup/Troubleshooting

• Hot Runner Temperature Controller

• 12 Zone Maximum per Tier

• 1 HBE-24 Female Connector for

Power per Tier (Standard)

• 1 HBE-24 Male Connector for

Thermocouple per Tier (Standard)

• Remote Mount Alarm Relay

• External Communications RS232/RS485

Version 1.3

GLC 2K Start Up Procedure

Dry Cycle Mold, Apply Full Tonnage, 3-4 Times (Pinch any wires in

advance of operation)

Turn Individual Zones "Off "

Turn "On" Main Disconnect

Select Zone or Zones, Press 1st Zone, Hold, Press Last Zone, Hold, Release.

All Zones Lit are Selected

Change Area – Select Temperature Set, Enter Set Point, Press Enter, All

Zones Selected will Change

Select Zone or Zones, Press 1st Zone, Hold, Press Last Zone, Hold, Release.

All Zones Lit are Selected

Change Area – Select Automatic/Manual Selection, Enter "0" for Automatic

Operation, Press Enter

Turn "On" Zone Power Switch. Apply Power to Manifolds first if required

by Manifold Supplier

Zones will read a Low Temperature Alarm, Zones are close or holding Set

Point When the Green Temperature Holding Set Point Light is Illuminated

Temperature Set

Enter

Gammaflux

Sterling, VA USA Tel. +1-(703) 471-5050

Wiesbaden, Germany Tel. +49-(0)-611-973430

Ube, Japan Tel. +81-(836) 54-4369

www.gammaflux.com; www.gammaflux.de

Select

Automatic/

Manual Selectionl

Select

Zone select indication

Temperature holding set point

Low temperature alarm