Century UK Neon Blaze CP V2.4G Manual de instruções do utilizador - Página 7

Procurar online ou descarregar pdf Manual de instruções do utilizador para Brinquedo Century UK Neon Blaze CP V2.4G. Century UK Neon Blaze CP V2.4G 18 páginas.

Imprimir página

Receiver Identification (Fig. 3):

1. ELEV. : Connect to the elevator servo.

2. AILE. : Connect to the aileron servo.

3. PIT. : Connect to the PIT servo.

4. RUDD. : Connect to the tail servo.

5. THRO. : Connect to the speed controller .

6. Not used.

7. Main motor signal cable : Connect to the main motor signal cable.

8. Tail motor signal cable : Connect to the tail motor signal cable.

9. MIX : Please regulate according to the flight effects, clockwise adjustment

increases the mixing ratio control, counterclockwise decreases the mixing

ratio control.

10. Servo extent adjustment (EXTENT) : EXTENT knob is used to set up

the servo travel. Clockwise adjustment increases the servo travel, and

counterclockwise adjustment decreases the servo travel.

11. LED. LED indicates the receiving status. Quick flash means the signal is

being received; LED on means the signal has been received; slow flash

means the signal fails to be received.

12. Main motor cable : Connect to the main motor.

13. Tail motor cable : Connect to the tail motor.

14. Power cable : Connect to the battery.

Switch Between Model I and Model II

Remove the battery pack and the 4 fixing screws in the back cover of your CUK-2601, and take off the back cover (Note: don't break the cables inside).

Unscrew the fixing screw of linkage using cross screwdriver and fix the linkage of another side using the screw. And then remove the throttle

arresting spring to fix in your expecting side. In this way, physical refit has been finished (Fig. 4).

Fig. 4

Receiver Identification

Fixing screw of linkage

Throttle arresting pring

Fig. 3

⑧

⑦

⑥

⑤

④

③

②

①

⑨

Power cable

⑦

MAIN MOT. SIG. (3 cables)

⑧

TAIL MOT. SIG. (1 cable)

Fig. 4-1

Throttle DIP Switch (switching

to left end fits ModelⅠ throttle

control; switching to right end fits

ModelⅡ throttle control).