Century UK Neon Blaze CP V2.4G Manual de instruções do utilizador - Página 8

Procurar online ou descarregar pdf Manual de instruções do utilizador para Brinquedo Century UK Neon Blaze CP V2.4G. Century UK Neon Blaze CP V2.4G 18 páginas.

Imprimir página

Battery Mounting and Adjustment

1. Battery pack mounting. Place the battery pack in the correct position of your helicopter

(Fig. 5).

2. CG balance. Put your helicopter in a horizontal ground and make the flybar vertical to the tail

boom of your helicopter. Lift your helicopter using your index fingers to support the two sides

of flybar, and check the balance. The tail boom should be level with the ground. If it is not,

move the battery pack backwards or forwards to balance. Always check the Center of Gravity

(CG) with the battery pack and canopy installed (Fig. 6).

Never charge the battery in the model.

Fig. 6

1. Swashplate check. Turn on the transmitter. pull down the throttle stick and throttle trim

to the lowest position, and put the elevator trim and aileron trim in the neutral position.

Check whether the swashplate is horizontal and level after the reposition of elevator,

aileron and PIT servos.

2. Swashplate adjustment. If the swashplate is not in a horizontal level, adjust via the

following two steps: ① elevator, aileron and PIT servos adjustment. Unscrew servo

bellcrank and take servo bellcrank down. Reconnect to the battery pack and adjust the

angle between the servo bellcrank and servo linkage rod at 90 degrees after the reposition

of elevator, aileron and PIT servos. And then tighten servo bellcrank screw (Fig.7).

② servo linkage rod adjustment. Adjust the servo linkage rod to parallel to swashplate

bottom level.

The transmitter provides servo exponential adjustment and can lock the adjustment parameters as below:

1. Open the transmitter power switch when adjust, turn the No.10 DIP switch to the "ON" position, let the V2 knob on the control panel point at

"0" position.

2. When V2 is tuned to 0 position, the curve is linear (Fig.7) ; When V2 is tuned to the "+" end, the servo curve will be changed in the form of exponential

(Fig.8); When V2 is tuned to the "-" end, the servo curve will be changed in the form of negative exponential (Fig.9).

3. Rotate the knob towards "+" end V2 to "-40 " position.

Flybar

Tail boom

Swashplate Adjustment

Exponential Function

Fig. 5

Fig.7

Battery pack

location

Horizontal

level of the

swashplate

Servo linkage

rod