CeoTronics CT-DECT Base Manual de Instruções - Página 13

Procurar online ou descarregar pdf Manual de Instruções para Auscultadores CeoTronics CT-DECT Base. CeoTronics CT-DECT Base 20 páginas. Headset for wireless duplex communication
Também para CeoTronics CT-DECT Base: Manual de Instruções (20 páginas), Manual de Instruções (20 páginas), Manual de Instruções (14 páginas), Manual de Instruções (14 páginas)

Imprimir página

Time Out

If a subscription is not successfully completed within maximum 2 minutes since starting the process, a

»timeout« occurs. The timeout is signalized by a sequence of 4 short low tones in the headset of the

CT-DECT Multi (PP), repeating in 4-second intervals.

After a timeout all CT-DECT Multi (PP) subscribed to a transceiver module need to be subscribed anew

to the CT-DECT Case (8). In the event of only one CT-DECT unit (PP) the subscription of this single

CT-DECT unit (PP) has to be repeated.

3.1.2.2

Example of subscribing a CT-DECT Multi (PP) to a CT-DECT Case (8) (FP)

The following describes the subscription procedure of a CT-DECT Multi (PP) to a CT-DECT Case (8)

(FP). The subscription of other CT-DECT Multi (PP) units is done likewise.

PLEASE NOTE:

After successful subscription, all CT-DECT Multi (PP) units and the CT-DECT Case (8) (FP) must

be switched off again before putting the DECT system into operation.

a. Make sure all CT-DECT units are switched off.

b. Plug the CT headset into the 6-pole jack of the CT-DECT Multi (PP) and put the headset on, but

leave it in switched-off condition.

c. Press the subscription button on the CT-DECT Case (8) (FP) and keep it depressed. Switch on the

CT-DECT Case (8) (FP) while the subscription button is depressed and keep it depressed for at

least another 5 seconds after switch-on. Then release the subscription button and continue directly

with step »d« in order to avoid a »timeout«.

d. Press on the CT-DECT Multi (PP) at least one of the five buttons of the push-button bank and keep it

depressed. Switch the CT-DECT Multi (PP) on while depressing the button and keep it depressed for

at least another 5 seconds since switch-on until you hear a descending 5-tone sequence in your

headset. Then release the button.

The subscription process has been initiated and you hear about every 2 seconds an intermittent

short high beep in the headset of the CT-DECT Multi (PP). An ascending 5-tone sequence, repeat-

ing in 4-second intervals, finally informs you that the subscription process has been completed suc-

cessfully.

If, after maximum 2 minutes, the subscription process was not successful, this is signalized by a se-

quence of 4 short low tones, repeating in 4-second intervals.

In that case, switch off again the CT-DECT Case (8) (FP) and the CT-DECT Multi (PP) and repeat

the entire subscription process.

f. After successful completion of the subscription process, switch off again the CT-DECT Multi

(PP) and the CT-DECT Case (8) (FP) before commissioning the units (chapter 3.2).