CeoTronics CT-DECT Base Manuale di istruzioni per l'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Cuffie CeoTronics CT-DECT Base. CeoTronics CT-DECT Base 20. Headset for wireless duplex communication
Anche per CeoTronics CT-DECT Base: Manuale di istruzioni per l'uso (20 pagine), Manuale di istruzioni per l'uso (20 pagine), Manuale di istruzioni per l'uso (14 pagine), Manuale di istruzioni per l'uso (14 pagine)

Time Out

If a subscription is not successfully completed within maximum 2 minutes since starting the process, a

»timeout« occurs. The timeout is signalized by a sequence of 4 short low tones in the headset of the

CT-DECT Multi (PP), repeating in 4-second intervals.

After a timeout all CT-DECT Multi (PP) subscribed to a transceiver module need to be subscribed anew

to the CT-DECT Case (8). In the event of only one CT-DECT unit (PP) the subscription of this single

CT-DECT unit (PP) has to be repeated.

3.1.2.2

Example of subscribing a CT-DECT Multi (PP) to a CT-DECT Case (8) (FP)

The following describes the subscription procedure of a CT-DECT Multi (PP) to a CT-DECT Case (8)

(FP). The subscription of other CT-DECT Multi (PP) units is done likewise.

PLEASE NOTE:

After successful subscription, all CT-DECT Multi (PP) units and the CT-DECT Case (8) (FP) must

be switched off again before putting the DECT system into operation.

a. Make sure all CT-DECT units are switched off.

b. Plug the CT headset into the 6-pole jack of the CT-DECT Multi (PP) and put the headset on, but

leave it in switched-off condition.

c. Press the subscription button on the CT-DECT Case (8) (FP) and keep it depressed. Switch on the

CT-DECT Case (8) (FP) while the subscription button is depressed and keep it depressed for at

least another 5 seconds after switch-on. Then release the subscription button and continue directly

with step »d« in order to avoid a »timeout«.

d. Press on the CT-DECT Multi (PP) at least one of the five buttons of the push-button bank and keep it

depressed. Switch the CT-DECT Multi (PP) on while depressing the button and keep it depressed for

at least another 5 seconds since switch-on until you hear a descending 5-tone sequence in your

headset. Then release the button.

The subscription process has been initiated and you hear about every 2 seconds an intermittent

short high beep in the headset of the CT-DECT Multi (PP). An ascending 5-tone sequence, repeat-

ing in 4-second intervals, finally informs you that the subscription process has been completed suc-

cessfully.

If, after maximum 2 minutes, the subscription process was not successful, this is signalized by a se-

quence of 4 short low tones, repeating in 4-second intervals.

In that case, switch off again the CT-DECT Case (8) (FP) and the CT-DECT Multi (PP) and repeat

the entire subscription process.

f. After successful completion of the subscription process, switch off again the CT-DECT Multi

(PP) and the CT-DECT Case (8) (FP) before commissioning the units (chapter 3.2).