IKEA IHW6362WM0 Instruções de instalação e manual de utilização e cuidados - Página 9
Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação IKEA IHW6362WM0. IKEA IHW6362WM0 28 páginas. 30" (76 cm), 35 7/16" (90 cm) wall-mount canopy range hood
Imprimir página
6. Use UL listed wire connectors
and connect white wires (F)
together.
Electrical Shock Hazard
Electricaly
ground blower.
Connect ground
wire to green and yellow ground wire
in terminal
box.
Failure to do so can result in death or electrical
shock.
7. Connect green (or bare) ground wire from home power supply
to yellow-green
ground wire (E) in terminal box using UL listed
wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Check all light bulbs to make sure they are secure in their
sockets.
11. Reconnect power.
n
C
When using both upper and lower vent covers, push lower cover
down onto hood and lift upper cover to ceiling and install with
two 2.9 x 6.5 mm screws.
NOTE: Upper vent cover may be reversed to hide slots.
D
C
.......................
A
...........................
S
A. Upper vent cover
B. Lower vent cover
C. 2.9 x 6.5 mm screws
D. Bracket
For reduced ceiling height installations, using the upper cover fix
it to its bracket, using the lower vent cover, push cover down
onto hood and snap vent into place around vent cover bracket.
1,
For non-vented (recirculating installations,
install charcoal
filter over grille on blower housing and turn filter handle
clockwise.
Repeat with other charcoal filter.
A. Blower housing
B. Filter handle
C. Charcoal filters
2. For all installations, insert back edge or metal filter into rear
channel of the filter opening.
3. Push handle toward the rear and push filter up.
4. Pull filter toward the front and insert into front channel.
Compete
....
Check Range Hood Operation
1. Move the light switch to "1" position. The light should turn on.
2. Move blower switch to "1" position. The blower should
operate.
3. Move the blower speed switch to "1" position for low speed,
"2" position for medium speed or "3" position for high speed.
4. Move blower and light switches to "0" position to turn off
blower and light.
5. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
Control Panel
The range hood controls are located on the front side of the
canopy.
.......... S
A. Light switch
B. Blower switch