IKEA IHW8305WS0 Instruções de instalação e manual de utilização e cuidados - Página 7

Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação IKEA IHW8305WS0. IKEA IHW8305WS0 28 páginas. 30"(76.2cm) wall-mount canopy

Imprimir página

Tape template in place, aligning the template centerline and

bottom of template with hood bottom line and with the

centerline marked on the wall.

¸%%¸¸¸

/_/F

A. Centerline

B. Lower support bracket

C. 5 x 35 mm screws

D. Mounting height reference

E. Fastener locations

F Waft

Place the lower support bracket on the template aligning it

with the traced rectangle. Mark centers of 3 fastener

locations through the template to the wall.

IMPORTANT: All screws must be installed into wood.

Remove the template.

9. Drill %4" (2.75 mm) pilot holes at 2 upper locations where

screws are being installed into wood.

10. Attach the lower support bracket to the wall using

2 - 5 x 35 mm screws at location marked on the template.

A. Lower support bracket

B. 5 x 35 mm screws

C. Centerline on wall

Vent Cover Bracket Assembly and Installation

1. Assemble the 3 pieces of the vent cover bracket using 4 -

4 x 8 mm screws provided. The assembled bracket should be

sized to fit inside the upper vent cover.

A. Vent cover bracket assembly

B. Upper vent cover

C. 4 x 8 mm screws

D. Adjustable

width

Install vent cover bracket to wall about 1/8"(3.0 mm) away

from the ceiling with 2 - 6 x 70 mm screws and 2 - 10 x 70

drywall anchors supplied.

i ...............................

A. Vent cover bracket

B. Centerline on wall

Complete

Preparation

1. Determine and make all necessary cuts in the wall for the vent

system. Install the vent system before installing the hood. See

"Venting Requirements"

section.

2. Determine the required height for the 1/2"conduit and drill a

11¼"(3.2 cm) hole at this location.

3. Run the 1/2"conduit through the hole. Run wire through the

1/2"conduit according to the National Electrical Code or CSA

Standards and local codes and ordinances. There must be

enough 1/2" conduit and wires from the fused disconnect

(or

circuit breaker) box to make the connection in the hood's

electrical terminal box.

NOTE: Do not reconnect power until installation is complete.

4. Use caulk to seal all openings.