Ganz ZC-DN4312 PHA Manual de operação - Página 4
Procurar online ou descarregar pdf Manual de operação para Câmara de segurança Ganz ZC-DN4312 PHA. Ganz ZC-DN4312 PHA 4 páginas. Mini dome color camera
Imprimir página
Installing the dome enclosure
1. Remove the dome cover and the camera linear
Gently turn the dome cover counter-clockwise to unlock and pull free of the dome base.
Remove the camera linear by gently pulling it free of the two notches (D4) in the camera
base (see fig. D)
2. Use the template to mark and prepare the mounting area
This installation sheet is designed to maintain the IP and NEMA rating independent of the
chosen installation method. Therefore, all mounting access positions are sealed until they
are ready to be used. When mounting the dome to a ceiling or wall using screws, use the
template to cut a hole as the circle marked"T5" with a hole cutter.
3. Open the required knock-out panel
Use a sharp knife or side cutter pliers to cut one of the side knock-outs (C3) to the size
required to allow cable insertion. Be careful not to hurt yourself or damage the camera
when using knives and side cutter pliers.
4. Mount the dome enclosure
Using one of the mounting schemes discussed overleaf (Methods for mounting the
enclosure), fix the dome enclosure in place.
5. Connect the connecters
All wires have been connected to the circuit board
sealed on the dome base. When the enclosure is
mounted securely to a surface, connect your video
out and power in the cables to the G1 and G2
connectors.
A service jack socket is also provided for
temporary video connection when focusing the
camera, using a corresponding optional service
cable.
Important: Use only a Class 2 certified power
supply.
6. Adjust the camera position
You can adjust the focusing position by rotating
and panning the camera base (see fig. E)
7. Install the camera liner
Carefully fit the camera linear (F1) over the camera base so that it snaps into place as
shown in fig F and does not obstructed the camera lens.
8. Replace the dome cover
Replace the dome cover (F2) and rotate to close it as shown in fig.F. Use the supplied
T2 screw to secure the whole enclosure (see fig. G)
9. Install the Quick Mount Kit (optional) (see fig.H)
a. Use the screws to adjust the position of the two locking arms on the Quick Mount
adapter.
b. Thread cables through the Quick Mount adapter (H1) and install it onto the dome
enclosure.
c. Attach Camera to Quick Mount Install Adapter using the thread.