Ganz ZC-DN4312 PHA Kullanım Kılavuzu - Sayfa 4

Güvenlik Kamerası Ganz ZC-DN4312 PHA için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Ganz ZC-DN4312 PHA 4 sayfaları. Mini dome color camera

Sayfayı Yazdır

Installing the dome enclosure

1. Remove the dome cover and the camera linear

Gently turn the dome cover counter-clockwise to unlock and pull free of the dome base.

Remove the camera linear by gently pulling it free of the two notches (D4) in the camera

base (see fig. D)

2. Use the template to mark and prepare the mounting area

This installation sheet is designed to maintain the IP and NEMA rating independent of the

chosen installation method. Therefore, all mounting access positions are sealed until they

are ready to be used. When mounting the dome to a ceiling or wall using screws, use the

template to cut a hole as the circle marked"T5" with a hole cutter.

3. Open the required knock-out panel

Use a sharp knife or side cutter pliers to cut one of the side knock-outs (C3) to the size

required to allow cable insertion. Be careful not to hurt yourself or damage the camera

when using knives and side cutter pliers.

4. Mount the dome enclosure

Using one of the mounting schemes discussed overleaf (Methods for mounting the

enclosure), fix the dome enclosure in place.

5. Connect the connecters

All wires have been connected to the circuit board

sealed on the dome base. When the enclosure is

mounted securely to a surface, connect your video

out and power in the cables to the G1 and G2

connectors.

A service jack socket is also provided for

temporary video connection when focusing the

camera, using a corresponding optional service

cable.

Important: Use only a Class 2 certified power

supply.

6. Adjust the camera position

You can adjust the focusing position by rotating

and panning the camera base (see fig. E)

7. Install the camera liner

Carefully fit the camera linear (F1) over the camera base so that it snaps into place as

shown in fig F and does not obstructed the camera lens.

8. Replace the dome cover

Replace the dome cover (F2) and rotate to close it as shown in fig.F. Use the supplied

T2 screw to secure the whole enclosure (see fig. G)

9. Install the Quick Mount Kit (optional) (see fig.H)

a. Use the screws to adjust the position of the two locking arms on the Quick Mount

adapter.

b. Thread cables through the Quick Mount adapter (H1) and install it onto the dome

enclosure.

c. Attach Camera to Quick Mount Install Adapter using the thread.