Makita 1804N Manual de instruções - Página 5
Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita 1804N. Makita 1804N 8 páginas.
Imprimir página
Removing or installing planer blades
CAUTION:
Tighten the blade installation bolts carefully when
•
attaching the blades to the tool. A loose installation
bolt can be dangerous. Always check to see they
are tightened securely.
Handle the blades very carefully. Use gloves or
•
rags to protect your fingers or hands when
removing or installing the blades.
Use only the Makita wrench provided to remove or
•
install the blades. Failure to do so may result in
overtightening or insufficient tightening of the
installation bolts. This could cause an injury.
013232
To remove the blades on the drum, unscrew the four
installation bolts with the socket wrench. The drum plate
comes off together with the blades.
2
3
4
5
013185
To install the blades, first clean out all chips or foreign
matter adhering to the drum or blades. Use blades of
the
same
dimensions
oscillation/vibration will result, causing poor planing
action and, eventually, tool breakdown.
2
3
1
4
5
6
7
002556
1. Bolts
1
2. Drum
3. Planer blade
4. Drum plate
5. Adjusting plate
and
weight,
or
drum
1. Inside edge of
gauge plate
2. Blade edge
3. Planer blade
4. Adjusting plate
5. Screws
6. Heel
7. Back side of
8
gauge base
8. Gauge plate
9
9. Gauge base
Place the blade on the gauge base so that the blade
edge is perfectly flush with the inside edge of the gauge
plate. Place the adjusting plate on the blade, then
simply press in the heel of the adjusting plate flush with
the back side of the gauge base and tighten two screws
on the adjusting plate. Now slip the heel of the adjusting
plate into the drum groove, then fit the drum cover on it.
Tighten the four installation bolts evenly and alternately
with the socket wrench.
For the correct planer blade setting
Your planing surface will end up rough and uneven,
unless the blade is set properly and securely. The blade
must be mounted so that the cutting edge is absolutely
level, that is, parallel to the surface of the rear base.
Below are some examples of proper and improper
settings.
5