Makita 1804N Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita 1804N. Makita 1804N 8 páginas.

Imprimir página

result in jamming by chips. For rough cutting, the depth

of cut can be increased, while for a good finish you

should reduce the depth of cut and advance the tool

more slowly.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or

•

the like. Discoloration, deformation or cracks may

result.

Sharpening the planer blades

002588

Always

keep

your

performance possible. Use the sharpening holder to

remove nicks and produce a fine edge.

004952

First, loosen the two wing nuts on the holder and insert

the blades (A) and (B), so that they contact the sides

004953

Immerse the dressing stone in water for 2 or 3 minutes

before sharpening. Hold the holder so that the both

blades contact the dressing stone for simultaneous

sharpening at the same angle.

1. Sharpening

holder

blades

sharp

for

the

1. Wing nut

2. Blade (A)

3. Blade (B)

4. Side (D)

5. Side (C)

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

013230

best

Use a screwdriver to remove the chip cover.

013231

Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be

performed by Makita Authorized Service Centers,

always using Makita replacement parts.

1. Limit mark

1. Screwdriver

2. Screw

3. Chip cover

1. Brush holder

cap

2. Screwdriver