Makita 1806B Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica Makita 1806B. Makita 1806B 10 páginas. Power planer
Também para Makita 1806B: Manual de instruções (17 páginas), Repartição das peças (3 páginas), Manual de instruções (13 páginas), Manual de instruções (13 páginas), Manual de instruções (11 páginas)

Imprimir página

Adjusting the depth of cut (Fig. 4)

Depth of cut may be adjusted by simply turning the

knob on the front of the tool.

Switch action

CAUTION:

Before plugging in the tool, always check to see that

the switch trigger actuates properly and returns to the

''OFF'' position when released.

For tool without lock button and lock-off button

(Fig. 5)

To start the tool, simply pull the trigger. Release the

trigger to stop.

For tool with lock button (Fig. 6)

To start the tool, simply pull the trigger. Release the

trigger to stop. For continuous operation, pull the

trigger and then push in the lock button. To stop the

tool from the locked position, pull the trigger fully, then

release it.

For tool with lock-off button (Fig. 7)

To prevent the trigger from being accidentally pulled,

a lock-off button is provided. To start the tool, press

the lock-off button and pull the trigger. Release the

trigger to stop.

Planing operation (Fig. 8)

First, rest the tool front base flat upon the workpiece

surface without the blades making any contact.

Switch on and wait until the blades attain full speed.

Then move the tool gently forward. Apply pressure on

the front of tool at the start of planing, and at the back

at the end of planing. Planing will be easier if you

incline the workpiece in stationary fashion, so that you

can plane somewhat downhill.

The speed and depth of cut determine the kind of

finish. The power planer keeps cutting at a speed that

will not result in jamming by chips. For rough cutting,

the depth of cut can be increased, while for a good

finish you should reduce the depth of cut and advance

the tool more slowly.

Sharpening the planer blades (Fig. 9, 10 & 11)

Always keep your blades sharp for the best perfor-

mance possible. Use the sharpening holder to

remove nicks and produce a fine edge.

First, loosen the two wing nuts on the holder and

insert the blades (A) and (B), so that they contact the

sides (C) and (D). Then tighten the wing nuts.

Immerse the dressing stone in water for 2 or 3

minutes before sharpening. Hold the holder so that

the blades both contact the dressing stone for simul-

taneous sharpening at the same angle.

Connecting a vacuum cleaner

For European countries and areas (Fig. 12 & 13)

When you wish to perform clean planing operation,

connect a Makita vacuum cleaner to your tool. Install

the nozzle (standard equipment) on the tool using the

screws provided. Then connect a hose of the vacuum

cleaner to the nozzle as shown in Fig. 13.

For other countries and areas

A nozzle and joint (optional accessories) are neces-

sary to connect a Makita vacuum cleaner to your tool.

Consult a Makita catalogue or representative on the

nozzle and joint.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Replacement of carbon brushes

(Fig. 14, 15 & 16)

Replace carbon brushes when they are worn down to

the limit mark. First, remove the chip cover and then

replace the carbon brushes. Both identical carbon

brushes should be replaced at the same time.

To maintain product safety and reliability, repairs,

maintenance or adjustment should be carried out by

Makita Authorized Service Center.