CORNING OptiTect Manual de início rápido - Página 16

Procurar online ou descarregar pdf Manual de início rápido para Equipamento de laboratório CORNING OptiTect. CORNING OptiTect 18 páginas.

Imprimir página

9 .5

Ground Cable

Attach the ring terminal on the ground wire to the ground stud

inside the cabinet (Figure 23). Add a washer and a nut and

tighten to a torque value of 23 in-lb.

10 . Splicing

Before splicing fibers, determine the fiber routing

configuration you will use in your splicing application. Buffer

tubes may enter the splice tray and have all fibers in the

buffer tube spliced at that time or stored in the tray for

splicing later. It is also possible to splice one fiber from a

buffer tube and express the remaining fibers out of the splice tray.

Key Notes for Splicing

•

Rotational access is provided to the splice trays within the splice housing.

•

Maximum of seven splice trays can be accommodated within the splice housing (one

reserved for Feeder splicing and six for Distribution splicing). Each splice tray holds six

heatshrink mass fusion splices for a maximum of 72 splices per tray.

•

Feeder splicing occurs in the bottom splice tray in the splice housing with Distribution

splicing in subsequent trays above.

•

Two sub-units (jacketed or braided tubing) with three 12-fiber ribbons per sub-unit can be

strain-relieved to each feeder splice tray.

•

Two sub-unit pigtails from the back of the Input Fiber Field panel to the feeder splice tray are

pre-routed at the factory and stored for splicing.

•

Two sub-units (jacketed or braided tubing) with three 12-fiber ribbons per sub-unit strain-

relieved to each distribution splice tray.

•

Two sub-unit pigtails from the back of the Distribution panel to the distribution splice tray are

pre-routed at the factory and stored for splicing.

Feeder cable (F1) will

route to the bottom splice

tray and the Distribution

cable (F2) will route to the

subsequent trays above

in preparation for splicing

(Figure 24). Pigtails from

the Distribution panel

and/or splitter inputs

have been pre-routed

and stored in the splice

housing. To gain access

to the bottom splice tray,

loosen the hook-and-loop

strap and remove the top

trays.

STANDARD RECOMMENDED PROCEDURE 003-873 | ISSUE 2 | APRIl 2016 | PAGE 16 OF 18

Distribution

Cable F2

Feeder

Cable F1

TPA-3702

Figure 23 — Attach Ground Wire to Bus Bar

Entry Exit

Factory Installed Pigtails

(Feeder and/or Distribution)

Figure 24 — Fiber Routing Configuration

KPA-0902