CORNING OptiTect Manual de início rápido - Página 17

Procurar online ou descarregar pdf Manual de início rápido para Equipamento de laboratório CORNING OptiTect. CORNING OptiTect 18 páginas.

Imprimir página

Step 1:

Remove the cover from the splice tray by

lifting up on the center of the cover and

sliding the cover from beneath the retaining

tabs at the end of the tray (Figure 25).

Step 2:

Secure the braided tubing to the splice tray

using cable ties. Pigtails are strain-relieved

to the holes nearest the outside edge of the

splice tray. Preroute 48 inches of ribbon (at

least 1 to 2 loops) inside the splice tray to

the organizer in the middle of the tray. Cut

the excess fiber.

Step 3:

Bring both cut ends and the splice tray to

the splicing equipment. Slide heatshrink

protectors onto the fibers.

IMPORTANT: Refer to the instruction manual for your splice

equipment for detailed splicing instructions.

Step 4:

Cleave, clean and splice the connectorized pigtails to the Feeder or Distribution

cable in accordance with the instructions provided with the splicing equipment.

Step 5:

Return and route the fibers within the splice

tray, securing the splice point within the

organizer and routing slack around the

organizer and within the interior of the tray

(Figure 26).

Step 6:

Reinstall the splice tray cover ensuring the

tray cover is captured beneath the retaining

tabs at the ends of the tray. Return the

splice tray to the rotating shelf within the

splice housing.

IMPORTANT: Labels have been provided in the splice tray kit to provide appropriate means of

identifying and recording each splice. Record splices on the label and adhere to the top

of each splice tray.

Step 7:

Secure splice trays to the splice tray shelf using the hook-and-loop strap provided.

Step 8:

Subsequent splicing within the remaining trays is to be handled the same manner.

11 . Installing Splitter Modules

Refer to the routing label on the inside of the cabinet door for a description of the cabinet layout

and installation sequence for installing modules. Preconnectorized output fibers fromthe splitter

modules can be mated inthe distribution field or routed to and stored in the connector parking

field for mating later. Follow procedure provided with the splitter module for instructions.

STANDARD RECOMMENDED PROCEDURE 003-873 | ISSUE 2 | APRIl 2016 | PAGE 17 OF 18

Retaining Tabs

KPA-0747

Figure 25 — Remove Cover from Splice Tray

Pigtail

Distribution

or Feeder

Figure 26 — Splice Fibers

KPA-0906