Garage Tek GT4011EE Manual de instruções de instalação - Página 4

Procurar online ou descarregar pdf Manual de instruções de instalação para Talhas de corrente Garage Tek GT4011EE. Garage Tek GT4011EE 8 páginas. Two point hoist

Imprimir página

TWO POINT HOIST - ASSEMBLY INSTRUCTIONS

STEP 5

SYSTEM SETUP

STEP #5: PLACE THE OBJECT TO BE HOISTED UNDER THE RING HOOKS AND TIE THE DROP CORDS TO THE

STRAPS. TRY TO TIE THE STRAPS ONTO THE DROP CORDS AT THE SAME HEIGHT.

STEP #6: FASTEN THE STRAPS TO THE OBJECT TO BE LIFTED AND ADJUST THE STRAP LENGTHS AS

NEEDED SO THE LOAD IS LEVEL.

STEP #7: SLOWLY PULL THE RAISING CORD TO CHECK THE LOAD IS LEVEL. (BOTH DROP ROPES MUST

HAVE EQUAL TENSION SO THE LOAD REMAINS LEVEL WHEN LOWERING OR RAISING.) THE METHOD USED

TO RAISE OR LOWER AND OBJECT IS SHOWN / EXPLAINED ON PAGE 2.

STEP 6

STEP 7

A FINAL SAFETY NOTE: NEVER RAISE OR LOWER AN ITEM WITH A PERSON UNDER

THE OBJECT.

PG 4

QUESTIONS ???? CALL 1-866 664 2724

REV 1, 01/1