CORNING Universal Access Tool 3 Manual de Instruções - Página 9
Procurar online ou descarregar pdf Manual de Instruções para Ferramentas CORNING Universal Access Tool 3. CORNING Universal Access Tool 3 9 páginas.
Também para CORNING Universal Access Tool 3: Manual de Instruções (18 páginas)
Imprimir página11. Troubleshooting
Symptoms
Possible Causes
Possible Causes and
Corrective Actions
A. Tool not splitting tube.
1.
Course adjustment backed
out too for
(1
turn)
1. Turn course adjustment all the
way cwckwise and back out to the
desired setting.
2. Broken blade
2.Replace blade
3. Blade adjustor needs
calilffation.
3. Callfor scroice. To check: screw
the course adjustment wheel all the
way cwckwise. When it bottoms out
against the
too~
the course wheel
should be flush with the tool surface
and the A index should align with
index mark on the tool body.
4.
Blade installed backwards
4.
Reinstall blade correctly.
5. Blade adjustor installed in
wrong halfoftool.
5.
Check T for top and B for bottom.
B. Tool slipping on tube.
1. Thumbscrew is
too
loose.
l.Tighten the thumbscrew slightly.
2. Thumbscrew is too tight.
Back offthe thumbscrew
and retighten until it is just "finger
tight. "
3. Excessive blade penetration
Retract the blade(s) and advance the
tool slightly by either pulling the tool
awng the tube by turning the handle
or by loosening the thumbscrew and
moving the tool slightly.
4. Blade in backwards
4. Reinstall blade correctly.
C.
Excessive force required to
Drivewheel bound
up.
Contact Corning Cable Systems
turn the drive handle and the
for service.
tool is slipping on the tube.
D. Broken blade tips
Tool improperly adjustedfor
Back both blade heights out to the
removal and storage.
Raised "A" position prior to remov
ing the tool from the tube.
Coming Cable Systems reserves the right to improve,
Coming Cable Systems LLC
enhance, and modify the features and specifications of
PO Box 489
Coming Cable Systems' products without prior notification.
Hickory, NC
28603-0489 USA
For US and Canada 1-800-743-2673
All trademarks are the property of their respective holders.
International
828-901-5000
C..oming Cable Systems is ISO 9001 certified.
FAX: 828-901-5973
© 2008
Coming Cable Systems LLC
http:WW-W.coming.comlcablesystems
All rights reserved.
Printed in U.S.A.
16