HIKVISION DS-7604 Series Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para DVR HIKVISION DS-7604 Series. HIKVISION DS-7604 Series 6 páginas.

Imprimir página

7. Click Start to begin backup process.

8. After the backup process has completed, you may select

the files from your device and click the Play button to

verify that it has been exported successfully.

Note:

Video Player software will automatically be copied

on to the device that the recorded files were exported on.

Configuring IP

Cameras

To configure IP cameras: (Take DS-7604HI-S as an

example.)

1. Enter the Camera Management menu by clicking Menu >

Setting > Camera.

2. Determine number of

analog channels to

disable. When you

want to connect

more than 2 IP

cameras at 4CIF

resolution or 1 IP

camera at HD720p resolution with the DS-7604HI-S unit,

then it needs to adjust the number of analog cameras

connected. 1 IP cameras at 4CIF resolution can be added

by disabling 2 analog

cameras, and 1 IP

cameras at HD720p

resolution can be

added by disabling 4

analog cameras. Up

to 4 IP cameras at

4CIF resolution or 2

IP cameras at HD720p resolution can be connected to the

DS-7604HI-S unit.

To disable analog channels, click the Status button to enter

the Camera Enabled Status menu. Uncheck checkboxes to

disable corresponding channels. Click OK to save setting.

A confirmation message will appear on the screen askin

you to reboot the DVR. Click Yes to reboot. After

system has rebooted,

enter back into the Camera

Management menu

and continue with

the following steps.

Select the Add butto

to enter IP Chan

nel

Settings menu.

Quick Start Guide - DS-7604 Series DVR

Select the IP device from the list. The devices found

list are those supported by SADP and found by

If no device was found, you may manually enter the

camera parameters in the fields below.

6. Enter IP camera parameters. This includes the IP address,

ports, user name and password of the IP camera.

7. Select OK to save and return to the Camera Management

menu.

8. If IP camera was

added successfully,

the Status for that

camera would show

that it is Connected.

If it does not, click

the Set button to verify that the parameters were entered

correctly. You may also delete an added channel by

clicking the Delete button.

9. Click OK to exit out of the Camera Management menu.

To adjust IP camera compression settings:

1. Enter the Record

Settings menu by

clicking Menu >

Setting > Record.

2. Select the General

tab.

3. Select the IP camera to configure next to the Camera

label.

4. Adjust IP camera compression settings. If the IP camera

was added successfully, the DVR will show OSD, channel

name and the compression parameters in accordance to the

IP camera's current settings.

5. Select the Sub Stream next to the Encoding Parameters

to set sub stream parameters. Sub stream is only used for

previewing.

6. Click OK to save and exit out of menu.

Note:

The quality of resolution, frame rate and bit rate

depends on the performance of the IP camera.

the

in the

the DVR.