HIKVISION DS-7604 Series Посібник із швидкого старту - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для ВІДЕОРЕЄСТРАТОР HIKVISION DS-7604 Series. HIKVISION DS-7604 Series 6 сторінок.
Друкувати сторінку7. Click Start to begin backup process.
8. After the backup process has completed, you may select
the files from your device and click the Play button to
verify that it has been exported successfully.
Note:
Video Player software will automatically be copied
on to the device that the recorded files were exported on.
Configuring IP
Cameras
To configure IP cameras: (Take DS-7604HI-S as an
example.)
1. Enter the Camera Management menu by clicking Menu >
Setting > Camera.
2. Determine number of
analog channels to
disable. When you
want to connect
more than 2 IP
cameras at 4CIF
resolution or 1 IP
camera at HD720p resolution with the DS-7604HI-S unit,
then it needs to adjust the number of analog cameras
connected. 1 IP cameras at 4CIF resolution can be added
by disabling 2 analog
cameras, and 1 IP
cameras at HD720p
resolution can be
added by disabling 4
analog cameras. Up
to 4 IP cameras at
4CIF resolution or 2
IP cameras at HD720p resolution can be connected to the
DS-7604HI-S unit.
3.
To disable analog channels, click the Status button to enter
the Camera Enabled Status menu. Uncheck checkboxes to
disable corresponding channels. Click OK to save setting.
A confirmation message will appear on the screen askin
you to reboot the DVR. Click Yes to reboot. After
system has rebooted,
enter back into the Camera
Management menu
and continue with
the following steps.
4.
Select the Add butto
n
to enter IP Chan
nel
Settings menu.
4
Quick Start Guide - DS-7604 Series DVR
5.
Select the IP device from the list. The devices found
list are those supported by SADP and found by
If no device was found, you may manually enter the
camera parameters in the fields below.
6. Enter IP camera parameters. This includes the IP address,
ports, user name and password of the IP camera.
7. Select OK to save and return to the Camera Management
menu.
8. If IP camera was
added successfully,
the Status for that
camera would show
that it is Connected.
If it does not, click
the Set button to verify that the parameters were entered
correctly. You may also delete an added channel by
clicking the Delete button.
9. Click OK to exit out of the Camera Management menu.
To adjust IP camera compression settings:
1. Enter the Record
Settings menu by
clicking Menu >
Setting > Record.
2. Select the General
tab.
3. Select the IP camera to configure next to the Camera
label.
4. Adjust IP camera compression settings. If the IP camera
was added successfully, the DVR will show OSD, channel
name and the compression parameters in accordance to the
IP camera's current settings.
5. Select the Sub Stream next to the Encoding Parameters
to set sub stream parameters. Sub stream is only used for
previewing.
6. Click OK to save and exit out of menu.
Note:
The quality of resolution, frame rate and bit rate
g
depends on the performance of the IP camera.
the
in the
the DVR.