Airglas GLH3000 Nose Ski Instruções para a aeronavegabilidade contínua - Página 8

Procurar online ou descarregar pdf Instruções para a aeronavegabilidade contínua para Aeronaves Airglas GLH3000 Nose Ski. Airglas GLH3000 Nose Ski 17 páginas. Ski kit for piper pa-18, pa-12, cc-18, s-18-180, sky international, inc. aviat a-1, a-1a, a-1b, a-1c-180, a-1c-200

Imprimir página

A modification to the landing gear must be accomplished at

skis. If the aircraft landing gear has been previously modified for the

penetration skis, then no modification is necessary. 8.50 x 6 tires are required. Because there is a

hydraulic pump that is required to actuate the skis, provision for this pump installation must be

considered too.

Airglas Inc.

they can also be operated with a hand pump.

1. The existing brake caliper torque plate will need to be rotated about 45 degrees upwards to

provide clearance for the yoke. The torque plate on the caliper may need to have 4 new holes

drilled halfway between the exiting holes.

2. The brake lines may have to be modified or changed to allow for the new position of the

caliper.

3. Prior to initial ski installation, the aircraft will need to be hoisted or jacked to attain clearance

enough to slide the ski beneath the tire. Once the ski is positioned, the aircraft may be

lowered to the ground.

4. The rod ends on the yoke can next be thru-bolted to the weldments.

5. The use of mechanical means to extend the forward Bungee, Safety Cable Assy. far enough to

attach it to the forward gear bolt will be necessary. Use caution when stretching the bungee.

6. Once the forward Bungee, Safety Cable Assy. is attached with the aircraft on the ground, the

rear Check Cable may be attached to the aft gear bolt.

7. Confirm the skis are at +1.5° (+1/-0) tip up in the ski position in flight with the ski in the

down position. (Measure relative to aircraft horizontal level position) No adjustment is provided

in cables. Contact

8. Make sure all hardware is installed, torqued, and cotter pinned as necessary.

All hardware in this kit shall be installed and torqued IAW AC 43.13-1B Chapter 7, Par 7-40,

Note:

Table7-1 and table 7-2

MANUAL REVISION B

THIS MANUAL INCLUDES INFORMATION PROPRIETARY TO

3.0 Installation

has designed the skis to work with an electric/hydraulic pump, but

Refer to drawings:

GLH3000-1-PA18

GLH3000-1-A1

GLH3000-6

GLH3000-7

SKI ATTACHMENT

(I f a hoist is used to lift the aircraft, it m ay be possible to lift it

high enough to pivot the ski and attach the bungee assem bly

w ithout stretching it.)

if ski position is not within tolerance.

Airglas, Inc.

(Continued on Next P age)

Airglas, Inc.

ASSEMBLY WITHOUT THE PRIOR WRITTEN PERMISSION OF

Airglas, Inc.

Installation (Piper type)

Installation (Aviat)

Hydraulic System

Electrical Schematic

AND SHALL NOT BE USED TO MANUFACTURE OR REPRODUCE ANY PART OR

Airglas, Inc.

Manual # GLH3000-105

for installation of the

Airglas, Inc.

27 July 2011

LW2500 fixed

8 |

P a g e