Airglas GLH3000 Nose Ski Инструкции по поддержанию летной годности - Страница 8
Просмотреть онлайн или скачать pdf Инструкции по поддержанию летной годности для Самолеты Airglas GLH3000 Nose Ski. Airglas GLH3000 Nose Ski 17 страниц. Ski kit for piper pa-18, pa-12, cc-18, s-18-180, sky international, inc. aviat a-1, a-1a, a-1b, a-1c-180, a-1c-200
Печатать страницуA modification to the landing gear must be accomplished at
skis. If the aircraft landing gear has been previously modified for the
penetration skis, then no modification is necessary. 8.50 x 6 tires are required. Because there is a
hydraulic pump that is required to actuate the skis, provision for this pump installation must be
considered too.
Airglas Inc.
they can also be operated with a hand pump.
1. The existing brake caliper torque plate will need to be rotated about 45 degrees upwards to
provide clearance for the yoke. The torque plate on the caliper may need to have 4 new holes
drilled halfway between the exiting holes.
2. The brake lines may have to be modified or changed to allow for the new position of the
caliper.
3. Prior to initial ski installation, the aircraft will need to be hoisted or jacked to attain clearance
enough to slide the ski beneath the tire. Once the ski is positioned, the aircraft may be
lowered to the ground.
4. The rod ends on the yoke can next be thru-bolted to the weldments.
5. The use of mechanical means to extend the forward Bungee, Safety Cable Assy. far enough to
attach it to the forward gear bolt will be necessary. Use caution when stretching the bungee.
6. Once the forward Bungee, Safety Cable Assy. is attached with the aircraft on the ground, the
rear Check Cable may be attached to the aft gear bolt.
7. Confirm the skis are at +1.5° (+1/-0) tip up in the ski position in flight with the ski in the
down position. (Measure relative to aircraft horizontal level position) No adjustment is provided
in cables. Contact
8. Make sure all hardware is installed, torqued, and cotter pinned as necessary.
All hardware in this kit shall be installed and torqued IAW AC 43.13-1B Chapter 7, Par 7-40,
Note:
Table7-1 and table 7-2
MANUAL REVISION B
THIS MANUAL INCLUDES INFORMATION PROPRIETARY TO
3.0 Installation
has designed the skis to work with an electric/hydraulic pump, but
Refer to drawings:
GLH3000-1-PA18
GLH3000-1-A1
GLH3000-6
GLH3000-7
SKI ATTACHMENT
(I f a hoist is used to lift the aircraft, it m ay be possible to lift it
high enough to pivot the ski and attach the bungee assem bly
w ithout stretching it.)
if ski position is not within tolerance.
Airglas, Inc.
.
(Continued on Next P age)
Airglas, Inc.
ASSEMBLY WITHOUT THE PRIOR WRITTEN PERMISSION OF
Airglas, Inc.
Airglas, Inc.
Installation (Piper type)
Installation (Aviat)
Hydraulic System
Electrical Schematic
AND SHALL NOT BE USED TO MANUFACTURE OR REPRODUCE ANY PART OR
Airglas, Inc.
Manual # GLH3000-105
for installation of the
Airglas, Inc.
27 July 2011
LW2500 fixed
8 |
P a g e